HP StorageWorks 2/32 - SAN Switch Instrukcja instalacji - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Przełącznik HP StorageWorks 2/32 - SAN Switch. HP StorageWorks 2/32 - SAN Switch 20 stron. Fabric manager version 3.0.x release notes
Również dla HP StorageWorks 2/32 - SAN Switch: Podręcznik użytkownika (22 strony), Informacje o wersji oprogramowania sprzętowego (14 strony), Uwaga dotycząca wydania (48 strony), Instrukcja instalacji (6 strony), Uwaga dotycząca wydania (32 strony), Uwaga dotycząca wydania (14 strony), Uwaga dotycząca wydania (4 strony)

To install the switch in a rack:

1. Check contents of the shipping carton to verify all the required parts and

2. Choose a mounting location in the rack for the switch.

3. Attach the rear mounting brackets to the rear rack uprights by completing one

Figure 2: Installing the rear mounting brackets (HP 9000 Series or comparable EIA

rack)

Caution:

For proper air flow, the SFP media side of the SAN Switch 2/32,

SAN Switch 2/16, or SAN Switch 2/8 must face the rear of the rack. This

mounting allows air to enter from the front of the rack and to exhaust at the

rear of the rack, similar to other rack-mounted equipment. This prevents switch

overheating, which may cause it to fail.

hardware are available.

of the following steps:

— For an HP 9000 Series or comparable EIA rack, assemble each of the two

brackets with (2) #10-32 x 1/2-inch Phillips pan-head screws with captive

star lock washers and (2) #10 adapter washers as shown in

SAN Switch Rack Mount Kit Installation Instructions

Figure