HP STORAGEWORKS ALL-IN-ONE STORAGE SYSTEM Instrukcja instalacji - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Przełącznik HP STORAGEWORKS ALL-IN-ONE STORAGE SYSTEM. HP STORAGEWORKS ALL-IN-ONE STORAGE SYSTEM 14 stron. 1u rackmount tape enclosure
Również dla HP STORAGEWORKS ALL-IN-ONE STORAGE SYSTEM: Instrukcje instalacji (2 strony), Instrukcja instalacji (20 strony), Uwaga dotycząca wydania (14 strony), Instrukcje instalacji (2 strony), Podręcznik referencyjny (46 strony)

To install the switch in a rack:

1. Check contents of the shipping carton to verify all the required parts and

2. Choose a mounting location in the rack for the switch.

3. Attach the rear mounting brackets to the rear rack uprights by completing one

Figure 2: Installing the rear mounting brackets (HP 9000 Series or comparable EIA

rack)

HP StorageWorks SAN Switch 2/8|16|32 Installation Guide

Installing the Switch in a Rack Using the SAN Switch Universal Rack Mount Kit

Caution:

For proper airflow, the SFP media side of the SAN Switch 2/32,

SAN Switch 2/16, or SAN Switch 2/8 must face the rear of the rack. This

mounting allows air to enter from the front of the rack and to exhaust at the

rear of the rack, similar to other rack-mounted equipment. This prevents switch

overheating, which may cause it to fail.

hardware are available.

of the following steps:

— For an HP 9000 Series or comparable EIA rack, assemble each of the two

brackets with (2) #10-32 x 1/2-inch Phillips pan-head screws with captive

star lock washers and (2) #10 adapter washers as shown in

Figure

Addendum Pg