HP StorageWorks FC Entry Switch 8B Podręcznik użytkownika - Strona 28

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Przełącznik HP StorageWorks FC Entry Switch 8B. HP StorageWorks FC Entry Switch 8B 44 stron. Isl trunking user's guide (version 3.0)
Również dla HP StorageWorks FC Entry Switch 8B: Podręcznik użytkownika (44 strony), Podręcznik użytkownika (38 strony), Podręcznik użytkownika (38 strony), Podręcznik użytkownika (37 strony), Podręcznik użytkownika (30 strony)

Using Advanced Performance Monitoring

Clearing End-to-End Monitor Counters

To clear all of the end-to-end monitor counters on a port, use the perfSetPortEEMask command to

reset all of the end-to-end monitor counters on that port.

Note:

To clear the counters for a single end-to-end monitor, delete the monitor using the

perfDelEEMonitor command, and then add the monitor again, using the perfAddEEMonitor

command.

Filter-based monitoring counts the number of times a particular command or frame type is received

by a port. Filter-based monitoring is achieved by configuring a filter for a particular purpose. The

filter can be a standard filter (for example, a read command filter that counts the number of read

commands that have been received by the port) or a user-defined filter that you customize for your

particular use.

The maximum number of filters is eight per port, in any combination of standard filters and

user-defined filters.

This section describes how to add standard filter-based monitors to a port. Use the telnet commands

listed in

Table 3-1

Telnet command

perfAddReadMonitor

perfAddWriteMonitor

perfAddRWMonitor

perfAddSCSIMonitor

perfAddIPMonitor

Example. These commands add several filter-based monitors to port 2 and display the results.

3-8

The perfSetPortEEMask command also sets the end-to-end mask, so if you do not

want to change the mask, you must re-specify the current mask settings. You can view

the current mask settings using the perfShowPortEEMask command.

Table 3-1

to define filter-based monitors on a port.

Telnet Commands to Add Filter-based Monitors

Description

Count the number of SCSI Read commands

Count the number of SCSI Write commands

Count the number of SCSI Read and Write commands

Count the number of SCSI traffic frames

Count the number of IP traffic frames

Advanced Performance Monitoring User's Guide