HP Xw460c - ProLiant - Blade Workstation Instrukcja instalacji - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Przełącznik HP Xw460c - ProLiant - Blade Workstation. HP Xw460c - ProLiant - Blade Workstation 10 stron. Mezzanine card installation instructions for supported hp proliant c-class bladesystem servers
Również dla HP Xw460c - ProLiant - Blade Workstation: Podręcznik wdrażania (35 strony), Podręcznik zapobiegania błędom (12 strony), Biała księga techniczna (12 strony), Aktualizacja oprogramowania sprzętowego (9 strony), Instrukcja instalacji (2 strony), Podręcznik często zadawanych pytań (14 strony), Plakat konfiguracji (9 strony), Instrukcja instalacji (33 strony), Podręcznik zarządzania (28 strony), Instrukcja obsługi sprzętu (23 strony), Przegląd (35 strony), Podręcznik użytkownika (33 strony), Podręcznik optymalizacji (13 strony), Ograniczona gwarancja (10 strony), Instrukcja instalacji (8 strony), Instrukcje instalacji (4 strony), Instrukcje instalacji (2 strony)

Insert the second Quadro FX 560M graphics board in the Mezzanine 2 connector using the three captive retaining

screws as shown below. Ensure that the graphics board connector is firmly seated in the Mezzanine 2 connector.

Reinstall the blade workstation in the rack by performing the following steps:

Install the blade workstation access panel.

Install the blade workstation in the rack.

Power up the blade workstation, and select Setup Mode during the boot process. This is in preparation for

installing the required version of RGS in Step 6, and assumes the continued use of the iLO 2 Remote

Console.

Step 6—Ensure that RGS 5.1.1 (or later) is installed, and verify RGS

operation

The final step is to ensure that RGS 5.1.1 (or later) is installed on the blade workstation—this is required for dual-

Quadro FX 560M graphics. Perform the following four steps to determine your RGS version, install RGS (if

necessary), and verify RGS operation.

To view the current RGS version, right-click on the RGS icon in the system tray, and select About to display

the RGS version. If the version is 5.1.1 or later, skip to step "d".

If you have purchased RGS update subscription services or RGS software assurance, you can download

RGS Workstation 5.1.1 (or later) for free from your subscription website. Otherwise, you'll need to purchase

RGS 5.1.1 (or later) from http://www.hp.com/go/softwaredepot.

After downloading RGS, follow the instructions in the RGS User Guide to install the RGS Sender on your

blade workstation.

Reboot the blade workstation. As the blade workstation reboots, change the Remote Console Mode to User

Mode. Follow your normal RGS connection procedure to verify that an RGS connection can be made to the

blade workstation.

- 10 -