Aquatel S207E Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Przyrządy pomiarowe Aquatel S207E. Aquatel S207E 8 stron. Wireless level indicator

Display Unit Set Up

Insert batteries into the

base of the Display Unit.

Note: Display Unit can alternatively

be powered by a 6V DC supply

The top light will flash as the

Display Unit calibrates and looks

for the Tank Unit. When the Tank

Unit is found the depth will be

displayed on the Display Unit.

8 lights means the tank is full,

2 lights means it is ¼ full.

Level Updates

If Tank Unit Mode Switch is set to 'test mode' – level updates every two seconds.

If Tank Unit Mode Switch is set to 'tank depth' – level updates 3-4 times an hour

(every 15-20 minutes).

LED Lights

The LED lights flash to notify you of any abnormal operating conditions.

(They flash even when the button is not pressed)

Signal has been lost – if this occurs regularly

check range (see next page)

Replace batteries in Tank Unit

Replace batteries in Display Unit

Reset Display Unit (hold down button).

If error persists reset Tank Unit.

If error still persists check range (see next page)

Tank Unit can not detect range due to

something blocking sensor, or the sensor is not

rotated so it is level with the liquid surface

The tank level has dropped very quickly.

Check for leaks. If this occurs without any fluid

loss, this could be a sign that your sensor is not

level to the water.

The tank is almost empty.

The red LED flashes and the Display Unit beeps.

Power Jack 6 Volts DC

300mA or higher

Centre pin positive 2.5mm

Insert 4 x AA batteries

in base of unit