aQuatell Fleck 5600SXT Instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Dozownik wody aQuatell Fleck 5600SXT. aQuatell Fleck 5600SXT 15 stron.

Putting it all together - Attaching the Brine Line to the Valve

The brine line connector on the Fleck valve is made of brass and located on the side of the valve.

It can be identified on the picture below.

With your softener hardware you will find a small plastic bag containing the hardware you need

to connect the brine line to the brine line connector on the valve. There are four small pieces in

the bag that need to be attached to brine line as in the picture below:

The brass tube insert and woven metal insert must both be pushed fully into the brine line. Once

all the pieces have been attached to the brine line push it into the brine line adapter on the valve,

and tighten down the brass nut to hold it in place. After completing this make sure that during

the process of attaching the brine line to the valve, that the brine tank connection did not loosen.

Putting it all together - Attaching the Drain Line to the Valve

The drain line port on the Fleck is located at the rear of the valve. Included in your pack of

hardware is a grey drain line barb that is threaded on one end (see orange arrow below). Screw

Page 8

Fleck 5600SXT U.S. V1.1