Diamond Products HS-20-F-12 Instrukcja obsługi - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Piła Diamond Products HS-20-F-12. Diamond Products HS-20-F-12 16 stron. Flush cut hydraulic hand saw
Drukuj stronęPERSONAL SAFETY
Read and completely understand instructions before operating saw.
•
DO NOT operate saw under the influence of drugs or alcohol.
•
Always wear safety approved hearing, eye, head and repertory protection.
•
Sturdy boots with non-slip soles aid in providing proper footing. Use of steel-toed safety boots is recommended.
•
•
Under certain conditions sparks may fly, therefore never wear clothes made of flammable material or operate near
flammable items.
Know how to stop the saw quickly in case of emergency.
•
Keep all parts of your body away from the blade at all times, blades are sharp and can cause serious injury or
•
death.
Do not use hands to search for hydraulic leaks, fluid escaping under pressure can penetrate skin and cause severe
•
injury. If any fluid is injected into the skin, seek medical attention immediately.
Wear heavy work gloves to avoid contact with concrete slurry, which can cause serious skin irritation.
•
BLADE SAFETY
Examine cutting blades before each use. Blades should have no cracks, nicks, or flaws. Center hole should be
•
undamaged as well. Use only blades recommended for your model.
This saw should cut only material that is specified on each cutting blade. Read instructions which are located on
•
the blade to determine which material the blade is designed to cut.
•
Use only steel centered diamond blades manufactured for use on concrete cutting hand saws DO NOT use high
speed steel blades, carbide tipped blades, or abrasive blades.
Inspect blade flanges for damage, excessive wear, and cleanliness before mounting blade. Blades should fit snugly
•
on clean, undamaged shaft.
Use only blades marked with a maximum operating speed greater than the blade shaft speed.
•
DO NOT remove flow control form hydraulic circuit. Do NOT exceed the maximum safely allowable speed. DO NOT
•
operate this equipment if you suspect it of exceeding this speed.
GENERAL SAW SAFETY
•
Always relieve all pressure before disconnecting hydraulic hoses. DO NOT apply pressure to damaged hoses or
fittings.
Always remember to keep both hands on the handles when the saw is running.
•
•
Never leave the saw unattended with the hydraulic hoses connected to power unit
CUTTING/WORK AREA SAFETY
Never operate the saw in any application or job where you are not trained or supervised.
•
Operate only in well ventilated areas.
•
Keep bystanders and or animals out of work area.
•
•
DO NOT operate the saw in areas of combustible materials or fumes. Sparks may occur from blade that could
cause a fire or explosion.
Know the material and work area you are sawing. Hazardous conditions such as live electric, water, or gas lines can
•
be concealed in material.
FAILURE TO COMPLY WITH THE PRECEDING WARNINGS COULD RESULT IN SERIOUS BODIILY INJUST OR DEATH!
HAND SAW SAFETY WARNINGS
.