Diamond Systems EMX-ESG Series Podręcznik użytkownika - Strona 15
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Systemy wejścia/wyjścia Diamond Systems EMX-ESG Series. Diamond Systems EMX-ESG Series 17 stron. Emx i/o module with 2 gigabit ethernet, 6 serial ports, and 14 gpio
Drukuj stronę7.2 Address and Protocol (J11)
Jumper J11 provides the configuration jumpers for the GPIO, serial port addresses and protocols and GPS as
outlined below.
The general purpose DIO pull-up/down setting is configured with two jumpers, one for pull-up (default) and the
other pull-down.
The base address for the SCH3116 is configured with two jumpers that connect pull-up/down resistors to the
DTR1 (A) and RTS1 (B) signals. These pins are read by the SCH3116 at power-up to define its base address:
DTR1 RTS1
0
0
0
1
1
0
1
1
Ports 1-2
2 jumpers for RS-232/422/485 configuration (RS-232 default)
Ports 3-4
2 jumpers for RS-232/422/485 configuration (RS-232 default)
Set COM6 to either serial port F or the GPS socket.
EMX-ESG User Manual Rev A.1
Base address
0x162E (default)
0x164E
0x002E
0x004E
Pin 1
Figure 4: Address and Protocol Jumper Block
www.diamondsystems.com
Page 15