Panasonic et-jpf100we Instrukcja obsługi - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Projektor Panasonic et-jpf100we. Panasonic et-jpf100we 16 stron.

Read this ﬁ rst! (continued)

IMPORTANT: THE MOULDED PLUG (U.K. only)

FOR YOUR SAFETY, PLEASE READ THE FOLLOWING TEXT CAREFULLY.

This appliance is supplied with a moulded three pin mains plug for your safety and convenience. A 13 amp fuse

is ﬁ tted in this plug. Should the fuse need to be replaced, please ensure that the replacement fuse has a rating

of 13 amps and that it is approved by ASTA or BSI to BS1362.

Check for the ASTA mark

If the plug contains a removable fuse cover, you must ensure that it is reﬁ tted when the fuse is replaced. If you

lose the fuse cover, the plug must not be used until a replacement cover is obtained. A replacement fuse cover

can be purchased from an Authorised Service Center.

If the ﬁ tted moulded plug is unsuitable for the mains socket in your home, then the fuse should be removed and

the plug cut off and disposed of safely. There is a danger of severe electrical shock if the cut off plug is inserted

into any 13 amp socket.

If a new plug is to be ﬁ tted, please observe the wiring code as shown below.

If in any doubt, please consult a qualiﬁ ed electrician.

WARNING:

THIS APPLIANCE MUST BE EARTHED.

IMPORTANT:

The wires in this mains lead are coloured in accordance with the following code:

As the colours of the wire in the mains lead of this appliance may not correspond with the coloured markings

identifying the terminals in your plug, proceed as follows.

The wire which is coloured GREEN - AND - YELLOW must be connected to the terminal in the

plug which is marked with the letter E or by the Earth symbol

AND - YELLOW.

The wire which is coloured BLUE must be connected to the terminal in the plug which is marked

with the letter N or coloured BLACK.

The wire which is coloured BROWN must be connected to the terminal in the plug which is

marked with the letter L or coloured RED.

How to replace the fuse: Open the fuse compartment with a screwdriver and replace the fuse.

 Panasonic assumes no responsibility for any accident or damage caused by improper



installation or incorrect handling.

or the BSI mark

on the body of the fuse.

Green - and - Yellow:

Blue:

Brown:

Earth

Neutral

Live

or coloured GREEN or GREEN -

ENGLISH - 3