Diamond Tech Powermiter IV Instrukcja obsługi - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Piła Diamond Tech Powermiter IV. Diamond Tech Powermiter IV 5 stron. Came saw

a. Blade guard assembly installation

The PowerMiter IV is fully assembled with the exception of the Blade Guard Assembly

and table height. All Diamond Tech power tools are product tested before shipping.

1. attach the Blade Guard Shield (a) to the Blade Guard arm (B) using the screw

provided (FiG.1). For extra strength, a dab of glue may be applied before fastening

the two components together.

2. Slide the metal Blade Guard hinge (c) into the slot located at the rear of the

Blade Guard assembly, opposite the Blade Guard Shield. attach by placing a

washer to one side of the arm and threading the bolt through the opening in the

washer and Blade Guard arm. add remaining washer and locking washer, fasten

in place with wing-nut (FiG.2).

3. attach Blade Guard assembly to the cutting Table (D). align the bottom hole of

the Blade Guard hinge with the Support Bracket at the rear of the cutting Table.

make sure the Guard hinge is on the right side of the Support Bracket. attach

by placing a washer to one side of the arm and threading the bolt through the

opening of the washer and Blade Guard arm. add remaining washer and locking

washer, fasten in place with wing-nut (FiG.3).

B. setting table Height

Depending on the depth of the material being cut, an adjustment of the cutting table

height may be necessary.

1. Loosen the height adjustment Knob, located on the right side of the saw motor,

opposite the power cord (FiG.4).

2. adjust by moving the table upward or downward to preferred height. Proper height

should be 1/8" to 1/4" above the top of the materials being cut. The lowest position

of the table allows for 3/4" of blade to be exposed. The maximum thickness of

materials being cut should be no more than 1/2" - 5/8".

3. Secure with the height adjustment Knob.

c. Blade replacement

warning: Before replacing blade, please make sure the saw is turned off and is

unplugged from the outlet.

1. Remove the cutting table by loosening the height adjustment Knob, located on

the right side of the motor opposite the power cord.

Page 2 - PowerMiter iv instruction Manual

Blade Replacement Diagram

cutting Table

Blade Guard Shield Screw

FiG.1

FiG.2

FiG.3