Diamond Tech Power Max II Instrukcja obsługi - Strona 4
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Szlifierka Diamond Tech Power Max II. Diamond Tech Power Max II 6 stron. Diamond tech power max ii glass grinder operations manual
Drukuj stronę
POWER MAX II INSTRUCTION MANUAL
Grinder Use and Maintenance
A. Bit Use
Remember to wear safety glasses or install a protective face shield
when grinding.
1) If you are a first time user, get the feel of the grinder by turning
on the grinder and grinding a piece of scrap glass. Begin by
pushing the glass into the grinding bit using light pressure
and moving the glass back and forth across the bit (Fig.9).
2) Slowly increase the pressure until you feel comfortable with
the grinding speed and your control. You'll quickly learn the
optimum grinding pressure for the types of glass you use.
3) Stop periodically and check the sponge placement and water
level. Grinding without water greatly reduces the life of
your grinding bits.
4) Over time, a bit may grind less effectively causing your glass
to chip, this is a result of wearing away of the bit's diamond
surface. When this happens, it is time to expose a new portion
of the diamond surface. Loosen the set screw using the hex
wrench and move the grinding bit up on the shaft to expose a
new 1/8" section of diamond.
5) Secure the bit back in place making sure to tighten it against
the flat side of the motor shaft. Reposition the sponge if needed.
6) The 1/4" grinder bit is useful for both drilling holes and intricate
grinding. To set up the 1/4" bit, simply install work surface,
then place the 1/4" bit directly into the top of the shaft making
sure the hex screw lines up with the flat side.
B. Care Information
1) NEVER GRIND DRY. Always make sure the sponge for the
grinder bit is wet while grinding.
2) While using the grinder bit, use only light to medium pressure
on the bit. Do not push material against bit using excessive
force. Unnecessary pressure will shorten grinder and grinder
bit life.
3) Clean water reservoir and Super Sponge™ after each use.
Remove water reservoir and flush out grinding residue
around the sides of the base. When cleaning or using large
volumes of water during grinding, remove the rubber stopper
(Fig. 10) from the grinder box and allow water to flush through
the drain (Fig. 11).
4) If the grinding bit becomes dry, add water directly to the Super
Sponge™.
5) To extend the life of the grinder, clean and lubricate the motor
shaft, inside openings of all bits and all set screws every 25
hours of use.
6) Grinder bits should be removed from the machine if they
are not in use for a week or more. This will keep them
from "cementing" to the shaft. It will also provide you with the
opportunity (and habit) of inspecting the motor shaft and bits
for proper care and maintenance.
7) DO NOT GRIND METAL. Doing so will destroy the bit and
make it unsuitable for grinding glass.
- PAGE 4
Drain
Fig.8
Fig.9
Fig.10
Fig.11