Panasonic PT-D5700E Arkusz informacyjny - Strona 6

Przeglądaj online lub pobierz pdf Arkusz informacyjny dla Projektor Panasonic PT-D5700E. Panasonic PT-D5700E 6 stron. Dlp based projector

Specifications

System
DLP™ Projection system
Device
0.7" (diagonal) DLP™ chip 4:3
Pixels
786,432 (1,024 x 768) x 1 total of 786,432 pixels
Lamp
275 W UHM lamp x 2 (Dual Lamp System)
1
Brightness (normal lamp)*
6,000 lumens (dual lamp, high power mode)
1
Contrast ratio*
2,000:1 (full on/full off, contrast mode: high)
Resolution
1,024 x 768 pixels
Lens
PT-D5700E
Powered zoom/focus lens,
Supplied lens: (1.8-2.4:1)
F = 1.7-2.0, f = 25.6-33.8 mm
PT-D5700EL
Optional powered zoom/focus lenses
Screen size
50 - 600 inches
Vertical: ±50% (powered), Horizontal: ±10% (manual)
Lens shift
RGB input scanning
frequency
f
15-91 kHz, f
H
V
Dot clock 150 MHz or lower
Component signal
480i, 480p, 576i, 576p, 720/60p, 720/50p, 1080/60i,
1080/60p 1080/50i, 1080/50p
Video signal
NTSC, NTSC4.43, PAL, PAL60, PAL-N, PAL-M, SECAM
Terminals
VIDEO IN
BNC
S-VIDEO IN
Mini DIN 4-pin
RGB1/YP
P
IN
BNC x 5
B
R
RGB2 IN
D-sub HD 15-pin
DVI-D IN
24pin DVI 1.0 compliant, HDCP compatible, for single link
RS-232C IN
D-sub 9-pin female
RS-232C OUT
D-sub 9-pin male
REMOTE 1 IN
M3 jack
REMOTE 1 OUT
M3 jack
REMOTE 2 IN
D-sub 9-pin female (parallel)
LAN
RJ-45x1, compliant with PJLink™ (class 1), 10Base-T/100Base-TX
±30˚ (with standard lens)
Keystone correction range
Installation
Front/rear, ceiling/floor
Power cord length
3.0m (9.9')
Power supply
220-240 V AC, 50 / 60 Hz
Power consumption
750 W (790 VA) (15 W during standby mode with fan stopped)
Dimensions (W x H x D)
530 x 167 x 429 mm (20-7/8' x 6-9/16' x 16-7/8') (without lens)
2
Weight*
PT-D5700E
Approx. 13.9 kg (30.6 lbs) with supplied lens
PT-D5700EL
Approx. 13.1 kg (28.9 lbs) without lens
Operating temperature
0 -45 ˚C (32 -113 ˚F)
Operating humidity
20-80% (no condensation)
Supplied accessories
Power cord, Wireless/wired remote control unit,
AA Batteries (x 2) for remote control, Wire rope
*1: Measurement, measuring conditions, and method of notation all comply with ISO 21118 international standards.
*2 Average value. May differ depending on models.

Projection distance

Diagonal
With ET-DLE100
With supplied lens*
With ET-DLE200
image
1.3-1.8:1
1.8-2.4:1
size
min.
max.
min.
max.
min.
1,335mm
1,812mm
1,785mm
2,376mm
2,454mm
50"
4.3'
5.9'
5.8'
7.7'
8.0'
2,163mm
2,928mm
2,895mm
3,840mm
3,966mm
80"
7.0'
9.6'
9.5'
12.6'
13.0'
2,715mm
3,672mm
3,635mm
4,816mm
4,974mm
100"
8.9'
12.0'
11.9'
15.8'
16.3'
4,095mm
5,532mm
5,485mm
7,256mm
7,494mm
150"
13.4'
18.1'
17.9'
23.8'
24.5'
5,475mm
7,392mm
7,335mm
9,696mm
10,014mm
200"
17.9'
24.2'
24.0'
31.8'
32.8'
8,235mm
11,112mm
11,035mm
14,576mm
15,054mm
300"
27.0'
36.4'
36.1'
47.8'
49.3'
10,995mm
14,832mm
14,735mm
19,456mm
20,094mm
400"
36.0'
48.6'
48.3'
63.8'
65.9'
13,755mm
18,552mm
18,435mm
24,336mm
25,134mm
500"
45.1'
,60.8'
60.4'
79.8'
82.4'
16,515mm
22,272mm
22,135mm
29,216mm
30,174mm
600"
54.1'
73.0'
72.6'
95.8'
98.9'
* The supplied lens is used only for PT-D5700E.
50-85 Hz
With ET-DLE310
With ET-DLE410
2.4-4.0:1
3.4-4.4:1
4.5-8.4:1
max.
min.
max.
min.
max.
4,044mm
3,379mm
4,444mm
4,493mm
8,515mm
13.2'
10.2'
14.4'
14.4'
27.8'
6,516mm
5,470mm
7,174mm
7,271mm
13,705mm
21.3'
23.2'
23.6'
17.7'
44.9'
8,164mm
6,864mm
8,994mm
9,123mm
17,165mm
26.7'
22.3'
29.1'
29.8'
56.1'
12,284mm
10,349mm
13,544mm
13,753mm
25,815mm
40.2'
33.7'
44.2'
44.9'
84.6'
16,404mm
13,834mm
18,094mm
18,383mm
34,465mm
53.8'
45.2'
59.3'
60.3'
112.8'
24,644mm
20,804mm
27,194mm
27,643mm
51,765mm
80.8'
68.2'
88.9'
90.5'
169.6'
32,884mm
27,774mm
36,294mm
36,903mm
69,065mm
107.8'
90.8'
118.7'
121.0'
226.3'
41,124mm
34,744mm
45,394mm
46,163mm
86,365mm
134.8'
113.8'
148.6'
151.2'
283.1'
49,364mm
41,714mm
54,494mm
55,423mm
103,665mm
161.9'
136.8'
178.4'
181.7'
339.8'
Dimensions

Optional accessories

Replacement Lamp Unit
ET-LAD57
ET-LAD57W (twin pack)
Zoom Lens (1.3-1.8:1)
ET-DLE100
Zoom Lens (2.4-4.0:1)
ET-DLE200
Zoom Lens (3.5-4.4:1)
ET-DLE310
Zoom Lens (4.5-8.4:1)
ET-DLE410
Fixed Focus Lens (0.8:1)
ET-DLE050
NOTES ON USE
1. Do not install the projector in locations that are subject to excessive water, humidity, steam, or oily smoke.
Doing so may result in fire, malfunction, or electric shock.
2. The projector uses a high-voltage mercury lamp that contains high internal pressure. This lamp may break,
emitting a large sound, or fail to illuminate, due to impact or extended use.
3. The projector uses of high-wattage lamp that becomes very hot during operation. Please observe the
following precautions.
• Never place objects on top of the projector while it is operation.
• Make sure there is an unobstructed space of 500 mm or more around the projector's exhaust openings.
With ET-DLE050
• Do not stack projector units directly on top of one another for the purpose of multiple (stacked)
0.8:1
projection. When stacking projector units, be sure to provide the amount of space indicated between
L
them. These space requirements also apply to installation where only one projector unit is operating at
794mm
2.6'
one time and the other unit is used as a backup.
• If the projector is placed in a box or enclosure, temperature of the air surrounding the projector must be
1,292mm
between 0 ˚C and 35 ˚C. Also make sure the projector's intake and exhaust openings are not blocked.
4.2'
Take particular care to ensure that hot air from the exhaust openings is not sucked into the intake
1,624mm
openings.
5.3'
* Even when the ambient temperature near the intake opening is 40 ˚C/104 ˚F or lower, an accumulation of hot air
2,454mm
inside the cabinet may cause the protective circuit to activate and shut down the projector. Please give ample
8.0'
consideration to the design with regard to ambient temperature conditions.
3,283mm
4. If the projector is to be operated continuously 24 hours a day, use the dual-lamp optical system's
10.7'
alternating lamp operation (lamp changer) function. The projector cannot be operated continuously 24
hours a day in dual-lamp mode. Allow a minimum of two hours per day of non-operation time per day if the
using the dual-lamp mode.
5. The lamp replacement cycle duration becomes shorter if the projector is operated repeatedly for short
periods.
• The length of time that it takes for the lamp to break or fail to illuminate varies greatly depending on
individual lamp characteristics and usage conditions.
• The brightness of the lamp will gradually decrease with use.
6. Please clean the filter regularly. As for details, please refer to the operation manual.
For more information about anasonic projectors. Visit ÐÐ
lease contact anasonic or your dealer for a demonstration.
530 (20 7/8)
Ceiling Mount Bracket
for high ceiling
ET-PKD56H
Ceiling Mount Bracket
for low ceiling
ET-PKD55S
http://panasonic.net/avc/projector
JQA-1617
All information included here is valid as of October 2008.
unit: mm [inch]