Panasonic PT-L6510E Instrukcja obsługi - Strona 11
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Projektor Panasonic PT-L6510E. Panasonic PT-L6510E 50 stron. 3600 ansi lumens sxga lcd projector 4200 ansi lumens xga lcd projector
Również dla Panasonic PT-L6510E: Broszura i specyfikacje (6 strony)
Drukuj stronę
Projector < Top · Front and Side >
Exhaust vents
Speakers
Speakers deliver a total audio output power of 6 watts
(3 + 3 watts each).
Line input (AC IN) socket (page 23)
Connect the accessory line power cord into this
receptacle. Do not connect any other cord to this
socket.
MAIN POWER switch (page 23)
Use this switch to turn " I " "O" the commercial line
power applied to the projector.
Burglar lock
Attach a commercial burglar prevention cable (e.g.
from Kensington) to this lock port. It is compatible
with the Micro Saver Security System from
Kensington. This security lock is compatible with the
Microsaver Security System from Kensington.
Contact details for this company are given below.
Kensington Technology Group ACCO Brands Inc.
2885 Campus Drive San Mateo, CA 94403
Tel (650)572-2700
Fax (650)572-9675
http://www.kensington.com/
http://www.gravis.com/
Air filter (page 41)
Leveling button (page 24)
Use these buttons (one on each side) to level the
projector when resting on its feet.
Leveling foot (page 24)
Use in conjunction with
adjustment.
(A leveling foot is provided on each side of the unit.)
Status LED lights
Side interface panel
Exhaust vents
for the projector's tilt
Status LED lights
(Viewed from the rear side)
(see page 13)
STAND BY (R) LAMP1
Remote control receiver window (page 14)
Receives IR commands transmitted from the remote
control.
Focus ring (page 23)
For focus adjustment.
Powered focus adjustment is also available.
Projection lens
Images are projected onto the screen through this
lens.
Lens cap
Cap the lens whenever the projector is left unused.
Power status light (page 23)
Lit in red when the projector is in standby mode with
MAIN POWER switch set to " I ". Lit in green when
the unit is turned ON.
Lamp 1 monitor (page 40)
Lights when lamp unit 1 requires replacement.
Flashes if the lamp 1 drive circuit is malfunctioning.
Lamp 2 monitor (page 40)
Lights when lamp unit 2 requires replacement.
Flashes if the lamp 2 drive circuit is malfunctioning.
Temperature (TEMP) monitor light (page 40)
Warns of unacceptable internal temperatures. May
be either continuously lit or flashing.
LAMP2
TEMP
ON (G)
11