Diamond Way K-Kub Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Maszyna podłogowa Diamond Way K-Kub. Diamond Way K-Kub 7 stron. Single phase floor grinder

Grinder runs but does

not perform adequately

Grinder vibrates during

use

Grinding noise coming

from grinding head

when up on jockey

wheel

Maintenance

Daily cleaning: The motor in use should always be kept clean. No water

droplets, cotton etc should be allowed to get into the interior of the motors.

Check on load current: While the motor is in operation, constant care should

be taken to keep the load current below the rated value.

Running sound: During the operation of the motor there must be no rubbing

noise shrike or other random noise. Stop the motor immediately and restart

after the corrections have been made.

Check the folding handle latch periodically. This is adjustable. To adjust loosen

the lock nut on the latch and then screw in the treaded paw until a satisfactory

tension has been achieved.

The wheel bearing are sealed type so they do not require regular greasing.

**NB to minimize vibrations and uneven blade wear, rotate plate every 2

hours.

Failure to do so can lead to premature wear of the flexible coupling.

General warranty conditions

• Six months warranty on the frame from the delivery date.

• Warranty covers all functional disturbances caused by defects in

material or manufacturing.

heavy enough cable

Motor defective

Grinding plates not

correctly balanced

Excessively worn motor

bearings

compatibility

Repair or replace

Replace or re-balance

the grinding plates

Have motor serviced

6 |

P a g e