Diamondback 180 Instrukcja instalacji

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Akcesoria samochodowe Diamondback 180. Diamondback 180 2 stron. For toyota tacoma 2005; toyota tacoma 2006; toyota tacoma 2007; toyota tacoma 2008; toyota tacoma 2009; toyota tacoma 2010; toyota tacoma 2011; toyota tacoma 2012; toyota tacoma 2013; toyota tacoma 2014; toyota tacoma 2015; toyota tacoma 2016; toyota taco
Również dla Diamondback 180: Instrukcja instalacji (2 strony), Instrukcja instalacji (2 strony), Instrukcja instalacji (2 strony)

Drukuj stronę

DiamondBackCovers.com / 800 935 4002

INSTALLATION GUIDE

60 minutes

Normal install time

PARTS INCLUDED:

180 Cover

PRE-INSTALLATION NOTES:

You'll need a second person to

help with this installation.

PREPARE THE CARGO BED & MOUNT THE COVER

Close the tailgate. Place the cover onto the cargo bed so that the

weatherstrip along the cover's rear angle is ﬁrmly compressed

against the inside edge of the tailgate.

Center the cover side to side.

Place the cap clamps under the nose of the T

panel, their top halves gripping the inside

ﬂange of the panel and their bottom

halves gripping the square-tube top rail

('16-up) or ﬁtting into the deck rail

system ('05-15). Tighten with a

9/16" socket.

Verify that the cover remains centered side to side and its rear

weatherstrip remains compressed against the tailgate.

Keep an eye out for these icons:

Cap Clamps (2)

If you have a 2016–up Tacoma, you should aﬃx the included

rubber gasket to your bulkhead prior to installing your cover.

Refer to the Bulkhead Prep Kit Installation Guide for details.

IMPORTANT!

Important installation information

Mounting Brackets (2)

1/8"

Hex Key

Gas Springs (4)

Use a 10mm socket to remove the

factory bolt and washer that are on the

cargo-bed wall directly below the

hollow section of the driver-side end

of the cover's T panel. Repeat on the

passenger side.

Place a mounting bracket at each end

of the T panel so that the bracket's top

leg overlaps the inside ﬂange of the

panel and its slot aligns with the factory

bolt hole.

Peel the adhesive backing from the top

leg of the brackets so they'll stay in

place as you attach them.

Re-insert each bolt through its

washer, through the bracket slot, and

into the factory hole. Re-tighten.

To get the weatherstrip compres-

sion necessary for its adhesive to

cure and the cover to keep out the

weather, have a second person

press down on the cover while

you're reinstalling the

factory bolts.

If you have a '05–15 Tacoma, you should aﬃx the included bulk-

head weatherstrip at this point. Refer to the Bulkhead Prep Kit

Installation Guide for details.

'05–up Toyota Tacoma

Helpful Hints

Tips to assist installation

TOOLS REQUIRED:

Ratchet Wrench

10 mm

Socket

If you are installing a Cross Bin, you should

start before installing the cover. Refer to page 2

of the Cross Bin Installation Guide for details.

CONTINUED ON REVERSE >

180

270

CVR-180.3

9/16"

Socket

7/16"

Socket