Diamondback CVR-3 Instrukcja instalacji

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Akcesoria samochodowe Diamondback CVR-3. Diamondback CVR-3 2 stron. Hard tonneau cover for '15–up colorado & canyon with the 61.7" cargo box

Drukuj stronę

DiamondBackCovers.com / 800 935 4002

INSTALLATION GUIDE

45 minutes

Normal install time

PARTS INCLUDED:

Cab Panel

Center Panel

Tail Panel

PRE-INSTALLATION NOTES:

If you are installing a cab guard or headache rack, you should

mount it prior to mounting your DiamondBack cover. Refer to its

installation guide for details.

MOUNT THE PANELS

Place the center panel across the

center of the bed, cheated slightly

toward the tailgate.

Since the cover is

slightly tapered,

make sure the

arrow sticker on

the underside of

the center panel is

pointing toward

the tailgate.

Attach the tail panel by angling it 90° from the bed rails, sliding its

driver-side, loop-shaped hinge knuckle fully onto the corresponding

center-panel hinge pin, then dropping its passenger-side, C-shaped

hinge knuckle fully onto its corresponding pin.

FIRST

To avoid hinge damage, make sure the C-shaped

hinge knuckle is fully engaged with its pin before

tilting the panel.

Lower the tail panel into the closed position.

Keep an eye out for these icons:

1/8" Hex Key

Plastic Bushings (4)

Cap Clamps (4)

90°

SECOND

FULLY MATED

'15–up Colorado & Canyon

with the 61.7" Cargo Box

IMPORTANT!

Important installation information

TOOLS REQUIRED:

Gas

Springs (4)

It's possible for one person to install a DiamondBack solo, but the

whole process, especially positioning the panels, adjusting the lock

rods, and connecting the cab-panel tethers, is easier with two people.

Repeat steps 2–3 for the

cab panel, starting this

time with the loop-shaped

hinge knuckle on the

passenger side.

Position the cover front to back so that the leading edge of

the closed cab panel lines up with the outside edge of the

center of the bulkhead.

Center the cover side to side on

the truck.

A x the center panel to the truck by placing a cap clamp at each of

the four interior corners of the underside of the center panel and

tightening them with a 9/16" socket.

Road vibration can loosen your clamps. Retighten them after

100 miles. Check them every time you haul on top.

HD SE

Helpful Hints

Tips to assist installation

9/16" Socket

Ratchet

Wrench

7/16" Socket

CONTINUED ON REVERSE >

CVR-3