Diamondback 64683 Instrukcja obsługi i instrukcje bezpieczeństwa - Strona 14
Przeglądaj online lub pobierz pdf Instrukcja obsługi i instrukcje bezpieczeństwa dla Piła Diamondback 64683. Diamondback 64683 20 stron. 7" heavy-duty tile saw with sliding table
Drukuj stronę
General Operating instructions
1. Adjust the Miter, Bevel, and Depth
settings as needed. Refer to page
12. Lock all settings in place.
2. Place the workpiece on the
Table and firmly against the
Miter Gauge and Fence.
3. Make sure the workpiece is clear of
the Blade and that the Switch is in the
off-position, then plug in the tool.
4. Insert the Safety Key and lift the Power
Switch up to the ON position.
5. With the Saw running, make sure the
Pump is supplying enough water to
the Blade. If needed, dry your hands,
turn off and unplug the Saw, adjust the
Pump's flow, dry your hands again,
plug the Saw back in and turn on.
6. Let the Blade build up to full
speed before cutting.
7. Use two hands and hold
workpiece securely against Table
and Fence at all times. Feed
the material into the Blade.
8. When the cut is made, turn the Saw
off. Wait for the Blade to come to
a complete stop before removing
any part of the workpiece.
9. To prevent accidents, turn off the tool,
remove the Safety Key, and unplug the tool
from its electrical outlet after use. Clean,
then store the tool indoors out of children's
reach. Store the Safety Key separate
from the tool and out of children's reach.
Page 14
For technical questions, please call 1-888-866-5797.
Straight cut
Miter cut
Bevel cut
Item 64683