Diamondback 64683 Instrukcja obsługi i instrukcje bezpieczeństwa - Strona 5
Przeglądaj online lub pobierz pdf Instrukcja obsługi i instrukcje bezpieczeństwa dla Piła Diamondback 64683. Diamondback 64683 20 stron. 7" heavy-duty tile saw with sliding table
Drukuj stronę
pOSitiOn OF tiLE SaW
Drip Loop
15. To avoid the possibility of the tool plug or
receptacle getting wet, position tile saw to one
side of a wall mounted receptacle to prevent
water from dripping onto the receptacle or plug.
The user should arrange a "drip loop" in the cord
connecting the saw to a receptacle. The "drip
loop" is that part of the cord below the level of
the receptacle, or the connector if an extension
cord is used, to prevent water traveling along the
cord and coming in contact with the receptacle.
16. If the plug or receptacle does get wet, DON'T unplug
the cord. Disconnect the fuse or circuit breaker
that supplies power to the tool. Then unplug and
examine for presence of water in the receptacle.
Extension cord Drip Loop
17. If an extension cord is used, the drip loop must be
before the cord connection and the extension cord
connection must be placed on an elevated surface.
Item 64683
tile Saw
power cord
Drip
Loop
tile Saw
power cord
Drip
Extension
Loop
cord
For technical questions, please call 1-888-866-5797.
EXtEnSiOn cOrDS
18. Use only extension cords that are intended for
outdoor use. These extension cords are identified
by a marking "Acceptable for use with outdoor
tools; store indoors while not in use." Use only
extension cords having an electrical rating not
less than the rating of the product. Do not use
damaged extension cords. Examine extension
cord before using and replace if damaged. Do
not abuse extension cords and do not yank on
any cord to disconnect. Keep cord away from
heat and sharp edges. Always disconnect
the extension cord from the receptacle before
disconnecting the product from the extension cord.
19. WARNING – To reduce the risk of electrocution,
keep all connections dry and off the ground.
Do not touch plug with wet hands.
20. Ground Fault Circuit Interrupter (GFCI) protection
should be provided on the circuit(s) or outlet(s)
to be used for the tile saw. Receptacles are
available having built-in GFCI protection and
may be used for this measure of safety.
aDDitiOnaL tiLE SaW SaFEty WarninGS
21. DO nOt OpEratE WitH any GuarD
DiSaBLED, DaMaGED, Or rEMOVED. Moving
guards must move freely and close instantly.
22. The use of accessories or attachments not
recommended by the manufacturer may
result in a risk of injury to persons.
23. When servicing use only identical replacement parts.
24. Do not depress the spindle lock when
starting or during operation.
25. Remove the Safety Key after each use.
Store the Safety Key separate from
the tool and out of children's reach.
26. Only use safety equipment that has been approved
by an appropriate standards agency. Unapproved
safety equipment may not provide adequate
protection. Eye protection must be ANSI-approved
and breathing protection must be NIOSH-approved
for the specific hazards in the work area.
27. Stay alert, watch what you are doing and use
common sense when operating a power tool.
Do not use a power tool while you are tired or
under the influence of drugs, alcohol or medication.
A moment of inattention while operating power
tools may result in serious personal injury.
28. Industrial applications must follow OSHA guidelines.
29. Maintain labels and nameplates on the tool.
These carry important safety information.
If unreadable or missing, contact
Harbor Freight Tools for a replacement.
Page 5