DIAQUIP QHS-400 Instrukcja obsługi - Strona 14

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Piła DIAQUIP QHS-400. DIAQUIP QHS-400 18 stron. Electric handsaw

Drukuj stronę
DIAQUIP QHS-400 Instrukcja obsługi
FLUSH CUTTING FLANGE (IF APPLICABLE)
FITTING & OPERATING
CONTENTS WITH THE FLANGE
1.
Flush Cutting Flange
2.
Socket Cap Arbor Bolt & Washer
3.
Flat-Head Socket Cap Screws x 6
4.
M5 L-Hex Wrench
5.
M8 L-Hex Wrench
INTRODUCTION
The flush cutting kit enables a flush cut 400mmØ
blade (not included) to be mounted to the machine in
order for flush cuts to be made while the outer blade
guard is temporarily removed. The flush cut blade
may be left in place and the operator may return to
standard cutting simply by replacing the outer blade
guard and securing it with the 3 toggle latches. This
way, it is quick and convenient to switch between
the standard mode and flush cutting mode. If more
appropriate for the operator & circumstances, the
flush cutting blade and flange may be removed
and the machine is then returned to the standard
configuration.
ASSEMBLY
To mount the flush cutting kit, first remove the standard arbor bolt, flanges and blade according
to the instructions below;
1.
Mount the flush cutting flange on the spindle and secure with the washer and socket cap
arbor bolt. Engage the arbor lock tighten the arbor bolt securely using the M8 L-hex
wrench.
2.
Mount the flush cut blade on the flange, align the holes and thread in the flat-head socket
cap screws. Using the M5 L-hex wrench, tighten the screws evenly and diagonally.
/26
1
1
1
2
1.
Toggle Latches
2.
Flat-head Socket Cap Screws
WWW.DIAQUIP.CO.UK
OPERATION
1.
Remove the water hose from the water nozzle
on the outer blade guard and connect it to
the alternate water nozzle on the inner blade
guard.
2.
Remove the 6 screws securing the outer
blade guard.
3.
Unclip the 3 toggle latches and pop the loose
clasps in the plastic clips to prevent rattling.
4.
Lift away the outer blade guard and keep in a safe place.
5.
Once the flush cutting operation is completed, immediately replace the outer blade guard
and water hose.
NOTE: There is roughly a 1mm or less effective offset (Depending on the width of the
diamond segments ). Since the blade guard has some degree of flexibility, pushing down
slightly brings it all the way to fully flush. In actual cutting, it comes out 100% flush.
There has to be a small degree of offset so the blade won't make marks in the base
material, in cases where it matters. So to avoid the marks, don't use any downforce.
But to get 100% flush, use some downforce.
WARNING: Always operate with the outer blade guard in place while performing standard
cutting. Never operate the saw with the outer blade guard removed except for flush
cutting operations.
WARNING: Check the tightness of the mounting screws and arbor screw periodically.
WARNING: If any unusual vibration is felt in operation, stop immediately and find the
cause before continuing.
WWW.DIAQUIP.CO.UK
Alternate Water Nozzle
/27