bioMetric SpinalPak Kompletny podręcznik - Strona 9

Przeglądaj online lub pobierz pdf Kompletny podręcznik dla Sprzęt medyczny bioMetric SpinalPak. bioMetric SpinalPak 20 stron. Non-invasive spine fusion stimulator system

Drukuj stronę

Operating Instructions

Both battery packs provided with the Biomet

SpinalPak

Non-invasive Spine Fusion Stimulator

System are charged prior to being packaged and distributed. Upon receipt of the Biomet

SpinalPak

Non-invasive Spine Fusion Stimulator System, it is recommended that the second battery pack be

immediately placed into the charger cradle and completely charged. In the meantime, the first battery

pack may be used to begin your treatment immediately. Note: The first battery pack may not provide

a complete 24-hour treatment initially.

STEP 1:

Following the arrows, insert the charged battery pack

(1, 2) into the Biomet

SpinalPak

Non-invasive Spine Fusion

Stimulator System (Figure 4). The LED light on top of the

device will blink, indicating power. Each symbol will be

indicated on the display and the alarm will flash and beep if

the electrodes are not properly applied. To silence the audio

alarm press the button below the display.

Figure 4

If the light does not blink, which indicates that the battery

pack is not charged, change the battery pack

(See Charging the Battery Pack below).

STEP 2:

Attach electrodes as per instructions on

Page 10, and as per "To Begin Treatment -

Electrode Placement" section on page 6.

Charging the Battery Pack

Charge the battery pack at room temperature (24°C (75°F)). Charging may require two to three hours.

Charging may vary in warmer or colder temperatures.

STEP 1:

Plug the battery pack charger and cradle into a wall outlet (Figure 5). A green light on the A/C adaptor

will illuminate indicating power (Figure 6).

Figure 6

Figure 5