4
AXIS 241Q/S Blade - Rack Solution Installation Guide
AXIS 241Q/S Blade Video Server
Read the following information to familiarize yourself with the AXIS 241Q/S Blade video
server making particular note of where the connectors and indicators are located:
Control Button
See the AXIS 241Q/S User's Manual for information on
the use of the control button.
Indicators
Network Amber
Green
Red
None
Status
Green
Amber
Red
Power
Green
Amber
Video In/Out
AXIS 241Q Blade - Accommodates up to 4 separate video
sources (VIDEO 1- VIDEO 4) simultaneously. Each
supported video input is terminated using a coax/BNC connector. Physical connections
made using RG59 75 Ohm coax video cable have a recommended maximum length of 800
feet (250 meters).
AXIS 241S Blade - Coaxial BNC connector supporting a single video source. The physical
connection is made using RG59, 75 Ohm coax video cable; with a recommended maximum
length of 800 feet (250 meters).
• A single video loopthrough (VIDEO OUT) connected in parallel with VIDEO IN and
terminated with a coax/BNC connector allows direct connection of an external monitor.
Set dip switch to OFF when in use.
• The AXIS 241S Blade supports conversion between composite video and Y/C (s-video)
using a Y/C to BNC cable (available as optional accessory). See the table on page 5 for
DIP switch settings.
Product Label
S/N (serial number) is identical to the unit's MAC/Ethernet address, e.g. 00408C1A2B3C =
00-40-8C-1A-2B-3C. P/N (part number) is the product model number.
Flashes for activity on a 10 Mbit/s network
Flashes for activity on a 100 Mbit/s network
Flashes rapid red for hardware error, together with
the Status indicator
No connection
Normal operation
Flashes during reset to factory default or at firm-
ware upgrade
Flashes rapid red for a hardware error, together with
the Network indicator
Normal operation
Flashes green/amber during upgrade
P/N: XXXX-YYY-ZZ
P/N: XXXX-YYY-ZZ
S/N: 00408C1A2B3C
S/N: 00408C1A2B3C
Top and bottom screws are used to
secure the blade server in the rack
Drukuj stronę