EasyPro EPLK2 Instrukcja obsługi - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Oświetlenie podwodne EasyPro EPLK2. EasyPro EPLK2 4 stron. 20 watt, 12 volt, submersible underwater lights

Drukuj stronę
Installation for EPL20 Lights:
1.
Before installing the product make sure
to check in the box for damaged or miss-
ing parts. Contact EasyPro immediately if
pieces are missing or damaged.
2.
Be sure the power is disconnected before
installing the lights.
3.
Connect the light fixture to its base by un-
threading the nut on the back of the light.
Slide the "C" shaped bracket onto the
back of the light and tighten nut.
4.
Place the light in the desired location of
your water feature.
5.
The submersible lights must be covered
with water at all times. Do not allow the water level to drop below the lights, as this can cause
the lens to crack and the bulbs to burn up due to excess heat.
6.
To adjust the light angle, use a phillips screwdriver and a pair of pliers to tighten the screw un-
der the "C" bracket.
7.
When installing the wires to the transformer, match up the corresponding color wires of each
light and connect the like colors to the transformer.
8.
Run the cable back to the transformer.
9.
Install transformer on a timer and enjoy.
10. Recommended 12 volt transformer for use with multiple lights is the EPT100/100 watt or larger.
Installation for RL20 Lights:
1.
Before installing the product make sure to check
in the box for damaged or missing parts. Contact
EasyPro immediately if pieces are missing or dam-
aged.
2.
Be sure the power is disconnected before install-
ing the lights.
3.
Place the light in the desired location of your water
feature.
4.
The submersible lights must be covered with
water at all times. Do not allow the water level to
drop below the lights, as this will cause the lenses
to crack and the bulbs to burn up due to excess
heat.
5.
Run the cable back to the transformer.
6.
When installing the wires to the transformer, match
up the corresponding color wires of each light and
connect the like colors to the transformer.
7.
Install transformer on a timer and enjoy.
10. Recommended 12 volt transformer for use with multiple lights is the EPT100/100 watt or larger.
2