Vive controller AC adapter: HTC, Model TC NE5W-US
TC NE5W-EU, TC NE5W-UK, TC NE5W-AU.
Base station AC adapter: HTC, Model TC NE30W-US,
TC NE30W-EU, TC NE30W-UK, TC NE30W-AU.
•
Handle battery packs carefully
The product controller contains a lithium-ion polymer or lithium-ion battery. There is a risk of fire and burns if
the battery pack is handled improperly.
Vive controller WARNING: To reduce risk of fire or burns, do not disassemble, crush,
puncture, short external contacts or circuits, expose to temperature above 60° C (140° F),
or dispose of in fire or water. Recycle or dispose of used batteries according to the local
regulations or reference guide supplied with your product.
•
Do not expose to liquid.
•
Keep batteries out of the reach of children.
•
Avoid dropping the product headset, controllers, or base stations. If dropped, especially on a hard surface,
and the user suspects damage, take it to a service center for inspection.
•
If the battery leaks:
•
Do not allow the leaking fluid to come in contact with skin or clothing. If already in contact, flush the
affected area immediately with clean water and seek medical advice.
•
Do not allow the leaking fluid to come in contact with eyes. If already in contact, DO NOT rub; rinse with
clean water immediately and seek medical advice.
•
Take extra precautions to keep a leaking battery away from fire as there is a danger of ignition or
explosion.
Safety precautions for direct sunlight
Keep the product away from excessive moisture and extreme temperatures. Do not leave the product in places
such as on a car dashboard, window sill, or behind a glass that is exposed to direct sunlight or strong ultraviolet
light for extended periods of time. The headset contains lenses which may focus and intensify bright light
sources, causing damage to the hardware.
Prevention of hearing loss
CAUTION: Permanent hearing loss may occur if Vive headset earphones are used at high volume
for prolonged periods of time.
Vive headset have been tested to comply with the Sound Pressure Level requirement laid down in the applicable
EN 50332-1and/or EN 50332-2 standards.
General precautions
•
Protect the product.
•
When installing base stations, avoid using unstable mounting accessories or surfaces that are prone to
vibration, movement or chance of impact.
•
A secure structure must support the weight or load of the base stations.
•
Do not install near a heater, fireplace, direct sunlight, air conditioning unit or other source of direct energy.
•
Do not attempt to pry open the base stations as it could result in injury.
•
Use only approved accessories.
•
Do not connect with incompatible products or accessories.
•
Do not attempt to disassemble this product or its accessories.
•
Use only qualified personnel to service or repair this product and its accessories.
•
Always treat the product and its accessories with care and keep them in a clean and dust-free place.
•
Do not expose the product or its accessories to open flames or lit smoking products.
4
Drukuj stronę