HTC 420 VS Podręcznik użytkownika - Strona 38

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Maszyna podłogowa HTC 420 VS. HTC 420 VS 46 stron. Floor grinder | concrete floor sander
Również dla HTC 420 VS: Podręcznik (50 strony)

Electronic Error Codes
Error code
Cause
PHF
PHF = Mains supply phase break
PHF flashes in the display for a few
seconds before it goes out. Occurs if
someone has pulled out the cord.
OPF
OPF = Motor phase break
Occurs when the motor plug has
not been plugged in correctly or is
loose. The fault may also be due
to the plugs or the terminal boxes
in the motor being loose. May also
occur if the machine goes into
overspeed during, for instance, test
operation with the grinding disc in
the air.
SLF
SLF = Faulty connection of remote
terminal.
Occurs if connection to a remote
terminal is faulty. May also be due
to an internal fault.

7.2.1. Resetting the frequency converter

1.
2.
3.
4.
Tip!
The machine will not start if the Grinding knob is in the "FWD"
mode when switching on the power.

7.2.2. Checking the last error code

1.
2.
3.
30
Switch off the machine by turning the Power knob to "O".
Wait until the display switches off.
Reset the emergency stop switch.
Start the machine by turning the Power knob to "I".
Press and hold ESC until four dashes (----) are shown in the
display.
Press ENTER when rdy (ready) is shown. SET is then
shown in the display.
Press "arrow down" until SUP is shown in the display.
HTC 420 VS
Action
Check the power supply to the
machine, i.e. the fuses and cable. If
the machine still does not function
after the power supply has been
checked, the fault may be due to a
fault on the contactor in the machine
or in the control panel. In this case,
contact HTC Service Centre.
Inspect the cable to the motor or the
terminal boxes in the motor. Reduce
the speed if you are test-operating
the machine in the air. The fault
occurs if the motor current is around
approx. 8% of the converter's
nominal current, which is 11 Amp
on 2.2 kW single phase.
Restart the computer. If the fault
remains, contact HTC Service
Centre.
3.0