EasyPro Vianti Falls HB11KEX Instrukcja instalacji - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Fontanna zewnętrzna EasyPro Vianti Falls HB11KEX. EasyPro Vianti Falls HB11KEX 4 stron.

Drukuj stronę

Assemble the

pump discharge

assembly into the

" bulkhead fitting

in the side of the

basin. Make sure

the bulkhead is

installed so the rubber gasket is inside the tub

and the nut with the plastic washer is outside

the tub. Take care not to cross thread or over

tighten the pump outlet assembly. Since this

connection should always be below water,

Teflon tape and over tightening is not required.

Install the

" swivel

fitting onto the

pump then carefully

lower the pump into

the basin. Connect

the pump discharge

assembly with the

" swivel fitting and ensure all connections are

snug.

Install

reducing

male adaptor in

bulkhead fitting on

outside of basin.

Wrap male threads

of fitting with

Teflon tape. Before

gluing black flexible PVC pipe verify all fittings

are tight. Place basin into position, cut the

black flexible PVC pipe to length and glue into

reducing male adaptor.

Care:

The water used in the Vianti Falls system can be treated with EasyPro All-Season

Bacteria and EasyPro Barley Straw Extract to help prevent odors and keep the water

clear. A liquid algaecide such as Pond Care's Algae Fix or Microbe-Lift's Algaway 5.4 can

also be used. Use of chlorine is not recommended, as this may have negative impact on

the submersible pump parts.

If water flow appears to be less than normal, water may need to be added to the basin

(bubbles in the waterfall typically indicate low water in the basin). A physical inspection

of the pump may be necessary. Clean off any debris that may have accumulated on the

pump housing or inside the pump. Consult instructions of pump for more information.

Do not run pump dry.

Staining on the spillway should not be an issue. Surface staining can often be remedied

with baking soda and lime juice application or non-abrasive products such as Bar

Keepers Friend. Be sure to follow manufacturer's directions and keep product from

entering water with fish and plants.

Should the splash mat need to be replaced, contact your local EasyPro dealer to

purchase replacement (part #HB11KM - 6" x 19" black splash mat).

After making sure all plumbing fittings

are properly installed, fill the basin with

water. Install basin supports and lid according

to basin assembly instructions. The spillway

should be tested for proper operation when

the wall construction allows. Before final wall

installation and covering the basin with rock, the

proper flow of the waterfall should be adjusted

(if needed) with the ball valve on the pump

discharge assembly.

Once proper

adjustment

of the spillway has

be determined, put

the pump cover in

place. The power

cord for the pump

can run through

the notch in the pump cover. The pump cover

can be placed in position as shown or reversed.

Place the splash mat underneath the waterfall.

Finish

construction

of the block wall

and any other

decorative stone

covering the basin.

Be sure to leave

rock off the area

of the splash mat

on the basin where

the water naturally wants to fall. This will reduce

splash and help retain water in the basin.

Teflon is a registered trademark of DuPont.