Dickson TH6P2 Pierwsze kroki - Strona 6
Przeglądaj online lub pobierz pdf Pierwsze kroki dla Rejestrator głosu Dickson TH6P2. Dickson TH6P2 7 stron. Remote sensing temperature/humidity recorder
Drukuj stronęWhy don't the display and chart match?
Why don't the display and chart match?
Why don't the display and chart match?
Why don't the display and chart match?
•
•
•
Why does the display read PROB?
Why does the display read PROB?
Why does the display read PROB?
Why does the display read PROB?
•
•
Why does calibration seem to be off?
Why does calibration seem to be off?
Why does calibration seem to be off?
Why does calibration seem to be off?
•
•
•
•
Why won't the battery back
Why won't the battery back
Why won't the battery back- - - - up work?
Why won't the battery back
•
•
•
Why won't the chart recorder respond to changes?
Why won't the chart recorder respond to changes?
Why won't the chart recorder respond to changes?
Why won't the chart recorder respond to changes?
•
Why won't the unit power up?
Why won't the unit power up?
Why won't the unit power up?
Why won't the unit power up?
•
Dickson TH6P Manual V5 052418
1.800.561.8187
Dip switches set for a specific range, but using chart for another range, or vice versa.
Pens(s) not inserted on pens arm(s) all the way
To adjust pens(s) to match chart see "Pens Home Adjust" in the "Need to Know" section
of this manual.
Check the sensor pod. Make sure it is properly plugged into the unit.
Is the unit locked up? This can be confirmed by pressing any of the buttons on the
keypad, if the unit is locked up there will be no response to button presses and the unit
may appear to be working, but the readings won't change, also the chart will not rotate.
Remove power and battery, and then re-power.
What is the tolerance of the unit it's being compared to?
It's ok if the unit is within the sum of the two tolerances.
Has an outside calibration house attempted calibration? It may not have been adjusted
properly.
Walk through calibration adjustment, found in the manual
up work?
up work?
up work?
Are there good batteries in the Chart Recorder?
Keep in mind that battery backup varies significantly depending on temperature, pens
movement and chart rotation speed.
If there was a momentary power outage (Brown out), the unit may not have had enough
time to recognize this and switch to battery mode. (The Chart Recorder may lock up or
shut off in this situation) This situation may also occur if the unit is plugged into an outlet
that shares the circuit with other machinery that has phase motors or compressors that
cycle periodically. As these other machines cycle, they momentarily have a high current
draw, therefore drawing from the unit.
Is the unit locked up? This can be confirmed by pressing any of the buttons on the
keypad, if the unit is locked up there will be no response to button presses and the unit
may appear to be working, but the readings won't change, also the chart will not rotate.
Remove power and batteries, and then re-power.
Remove the batteries and power adapter for a minute or two, this will reset the unit. The
unit should respond when the adapter is plugged in.
www.
6
.com