Dickson TK856 Pierwsze kroki

Przeglądaj online lub pobierz pdf Pierwsze kroki dla Rejestrator głosu Dickson TK856. Dickson TK856 8 stron. Remote sensing temperature recorder

Drukuj stronę

DICKSON

DICK

SON

GETTING STARTED

7-day chart rotation

0 to 100

QUICK START

1. 1. 1. 1. Remove the protective pen cap(s).

2. 2. 2. 2. Connect Probe(s):

KT8P0/2/3: Make sure the KTC probe is connected firmly to the Replaceable

Sensor and that the Replaceable Sensor is plugged in firmly to the chart recorder.

b. KT856: Make sure both KTC probes are plugged in firmly to the chart recorder.

3. 3. 3. 3. Insert batteries and plug in AC adapter (See Figure 3). KT8P0:4 AA batteries required;

KT8P2/3 & KT856: 4 AA batteries backup power only (See page 5 for backup life). Unit

will power on.

4. 4. 4. 4. The instrument will move pen(s) to the appropriate readings.

5. 5. 5. 5. Install the chart that matches the Dip Switch settings (See p.4).

Press the PEN

PEN HOME

HOME key to move the pen(s) to the outside of the chart. The pen(s) is

PEN

HOME

automatically raised off the chart.

Remove the old chart, place the new chart on the Chart Hub being certain that the edge

of the chart slides under the Chart Guide Clips located at the outside of the chart.

6. 6. 6. 6. Set the appropriate time. There are two ways to adjust the chart and set the appropriate

time:

Set the chart time manually by inserting a coin into the groove in the chart hub

and turning clockwise until the correct hour (and day if applicable) on the chart is

referenced to the timing arrow (just to the right of the pen tip on the dial). Press

Pen

Pen Home

Home to move the pen(s) back onto the chart.

Pen

Home

The following feature should be used for fine adjustments only.

b. To adjust the chart time, press and hold Adjust

located on the back of the unit next to the dip switch (see Figure 3).

The green LED will blink rapidly for about five seconds, then the LED will remain

solid green. While in this state the Adjust

backward (counter clockwise) and the Adjust

forward (clockwise).

Rotate the chart until the correct hour (and day if applicable) on the chart is

referenced to the timing arrow. Once you have set your chart, press the Pen

Home button to exit Chart Adjust Mode. The unit will take one minute to exit the

Home

Chart Adjust Mode once Pen

pen(s) back onto the chart.

Place the KT8 recorder on a flat vibration-free surface. Be sure it is in a vertical

position and level. For best performance and longevity, the location should be a

clean environment, free from dust and corrosive fumes. Do not exceed

temperature specifications. Wall Mount:

recorder for wall mounting.

Dickson KT8P Manual V6 52418

Remote Sensing

Remote Sensing Temperature

Adjust- - - - Up

Up and Adjust

Adjust

Adjust- - - - Up

Adjust

Up button will move the chart

Adjust

Adjust- - - - Down

Adjust

Down button will move the chart

Down

Pen

Pen Home

Pen

Home

Home is pressed. Press Pen

Wall Mount:

Wall Mount: Keyhole slots are provided on the KT8

Wall Mount:

KT8P0/2/3 & KT856

Temperature Recorder

Temperature

Recorder

Adjust- - - - Down

Down buttons

Adjust

Down

Pen

Pen Home

Pen

Home

Home to move the