dicodes Dani Box Podręcznik - Strona 9
Przeglądaj online lub pobierz pdf Podręcznik dla Vaporizery dicodes Dani Box. dicodes Dani Box 14 stron.
Drukuj stronę
05 Main Menu (Page 5)
Fire Button
Power
PBoost=1,2,3
Plim
Power
Extended Functions Menu
The Extended Functions Menu provides three sub-menus:
Heater Menu
Mod Menu
Value Menu
The Extended Functions Menu offers many setting options in order to provide the highest possible
flexibility for users to adjust performance to their preferences. Normally, once the settings are made,
the user will rarely need to change them.
The large number of options may initially intimidate some the users. But without the Extended
Functions menu the mod would not be able to address all of the different customer requirements.
Please take a bit of time to get familiar with the menu. We're confident that, once you have an
overview, setting your preferences will be relatively easy.
Error Messages
If an error occurs, the mod directly jumps to the error menu and displays the error
number and a mnemonic (short-term) description.
The possible error messages are:
0 OvrVolt:
The input voltage is too high. The
If the input voltage exceeds 4.5V this error message is displayed. Reduce the input
voltage to the specified range.
1 ChkAtom: No atomizer detected or open coil.
2 TempRef: A problem during the temperature reference measurement occurred
3 HighR:
The resistance of the coil is too high for the selected output power. The maximum output
voltage is 12V and current is 20A. This specification together with a maximum output
power of 60W leads to a resistance range of 0.15-2.4 Ohms. Also see "8 LowR". Higher
and lower resistances are possible, but the power has to be reduced accordingly.
Example 1: With a 4Ohm coil the maximum power is (12V)²/4 Ohm=36W.
Example 2: With a 0.12Ohm coil the maximum power is (20A)²*0.12 Ohm
= 48W. Note that for resistances >2.4 Ohm the output voltage is the limiting
factor, whereas for resistances <0.15 Ohms it is the current.
4 OverCur: Short on coil or coil breakdown (open)
5 LowBat:
The battery voltage under load (with current drained from it) has reached the minimum
discharge level—defined with parameter UbatMin in the extended function mod-menu.
6 EleHot:
The electronics have overheated and need to cool down. This error will not occur
with normal use of the mod.
7 TimeOut: The maximum puff-time is limited depending on power. For a power <20W it is 20
seconds. Above 20W it decreases by 0.5seconds per Watt, above 40W it is 10seconds.
8 LowR:
The coil resistance is too low for the selected power, please see "3 HighR".
Diagram for Boost-Function
Power
Plim
Time
Settings related to the heater or coil
Settings related to the individual usage and appearance
Provides several statistics of vaping
dicodes Dani Box
Fire Button
PBoost=4..10
is prepared for the use of one battery.
Time