Epcom PROAUDIO SFB120 Instrukcja obsługi - Strona 10
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wzmacniacz Epcom PROAUDIO SFB120. Epcom PROAUDIO SFB120 15 stron. Public address system
Drukuj stronę
5. OPERATION ILLUSTRATION
7.Mobile phone Bluetooth connection method:
①
Press the MODE button on the MP3 player to set the module to Bluetooth mode. The LCD will
"
"
display "bt" on screen, and while in Bluetooth mode, this mark will always be present. As soon
as you enter "bt" mode the device is ready to pair and sync with another Bluetooth device in the
vicinity.
②
Activate Bluetooth on your mobile device (phone or tablet or laptop). Check the mobile device
for any newly scanned devices. The Bluetooth label for the SFB120/SFB240 is "PA-02086".
③
If that device shows up on your mobile devices list, then select it and begin the pairing process.
④
Once the new "bt" playback device is connected, you can commence playing songs and audio
podcasts from your phone through the amplifier module.
⑤
Transport controls on the MP3 player are in sync with the phone. Press "Play/Pause" on the
module and the mobile device will play or pause. Press "Next" or "Previous" and the current
track will restart. You can also change the audio playlist from the phone, as well as pause,
skip etc.
8. MP3 module recording function description:
①
Insert SD card or USB device into the corresponding interface of MP3 module.
②
Press the "Play/Pause" (
mode, as shown by "REC" on the LCD screen. The recording onto whichever media is available
begins immediately the timer starts to count up. Only the connected audio sources (Mic 1- 4,
Aux 1-2) that have volume up will be recorded in the Master mix recording.
③
After recording ends, press "MODE" button to save and start to play the recording file.
④
User can press the last song and the next song button to play the required recording file.
9. FM Playback mode
①
Connect the FM antenna wires to the "FM ANT" sockets on the rear of the unit. Place the
antenna wire close to a nearby window to optimise signal reception.
②
FM mode is the default mode when the amplifier is first switched on, unless a USB or SD card
is inserted. If either of these media is inserted during FM playback, the mode will switch to
that media and commence playback automatically. Press the mode button repeatedly to return
to FM Tuner mode, which is indicated by the appearance of an FM frequency on the LCD screen.
③
Press "Play/Pause" (
The search will stop on any strong signal that it can pick up and commence playback. Press
"Play/Pause" again to restart the search, which proceeds in one direction from lower to higher
FM frequencies.
④
To tune to an FM station manually in 1MHz steps, use the "NEXT" or "PREVIOUS" arrow button
on the MP3 player until you find the desired frequency.
) button on the MP3 module for 3 seconds to enter the recording
:
) on the MP3 player to start the automatic search for FM Frequencies.
10