Alpha Technologies Blue Gate A Brave Instrukcja instalacji - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Gateway Alpha Technologies Blue Gate A Brave. Alpha Technologies Blue Gate A Brave 19 stron. Gsm gate

Drukuj stronę

requires PIN, which is not preprogrammed or is

preprogrammed wrongly.

 The LED „communication to GSM„ is flash shortly one for

2 sec. After calling to BlueGate you are hearing busy

tone. BlueGate is not log into GSM network – bad signal.

 The yellow LED „communication to GSM„ is flashing up

signal strength". After calling to BlueGate is not light up

green LED is not light up and in analogue phone is quiet.

It interrupted conduction of analogue line or so much big

resistance in current loop (for example:( longer cabel

between PBX and BlueGate).

 Tle yellow LED „communication to GSM„ is flashing up

signal strength" as same as green LED lights up. Tle

PBX hold „pick up" line of GSM Gate. By incoming call

you can remove this issue. In other cases check PBX

manual.

 The BlueGate works but call is disturbed by interference.

Incorrect position of antenna against telephone line.

Change antenna position.

Note:.

Default you make by parametr 99 in programming mode (via

programming table at page 11).

Alle LEDs flashing as same as tone types are mentioned in

tables at the end of manual.