DieHard 200.713151 Instrukcja obsługi - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Ładowarka DieHard 200.713151. DieHard 200.713151 17 stron. 15/2/125 amp fully automatic battery charger engine starter

Drukuj stronę

sparking occur, it will be at a distance

from the battery. NOTE: The battery

cable is not provided with the charger,

but may be purchased at most

automotive stores.

NEGATIVE

GROUNDED

SYSTEM

Figure A

pointer will fail to about half the charge

rate selected. For specific positions,

refer to the "Ammeter" section in

"Using Your Battery Charger" on

page 6.

10. When the battery is fully charged,

first unplug the charger power cord.

Then, standing away from the

battery, remove the charger clamp

from the chassis first, then from the

battery post.

11. Clean and store the battery charger in

a dry location.

Charging your battery

outside the vehicle:

1. Remove the battery frem vehicle,

making sure to disconnect grounded

terminal first with all accessories and

lights turned off in the vehicle.

2. Check the polarity of the battery posts

as indicated on the battery case:

POSITIVE (POS, P, +) and

NEGATIVE (NEG, N, --). NOTE: On

top-post batteries, the positive battery

terminal usually has a larger diameter

post than the negative one.

3. Connect the red (POSITIVE) charger

clamp to the POSITIVE post of the

battery. Be sure to rock the clip back

and forth to make a solid connection.

4. Attach a 6-gauge

(AWG) or a 4-gauge

(SAE) insulated

battery cable at least

24-inches

long to the NEGATIVE

battery

post. This cable will provide a

safer connection,

if arcing and

10.

11.

Take the other end of the 6-gauge

(AWG) or a 4-gauge (SAE) insulated

24-inch cable and, standing as far

away from the battery as possible,

connect the black (NEGATIVE) lead of

the charger to the free end of the

cable. Rock the clamp to make a solid

connection.

IMPORTANT:

Wear

safety glasses and face away from the

battery while making this connection.

For automatic charging, select

AUTOMATIC REGULARor

AUTOMATIC DEEP CYCLE

depending on the type of battery, then

select a charge rate. The charger will

quit when the battery is fully charged

and will restart if the battery voltage

drops too low.

For manual charging, select MANUAL

as a charge type, then select a charge

rate. The charger will not stop

charging when the battery is fully

charged; you must monitor and

unplug charger when battery is fully

charged. Avoid over charging;

monitorthe AMM ETER frequently

when in the manual mode.

Plug the power cord into an AC outlet.

When the battery is fully charged in the

MAN UAL mode, the AMMETE R pointer

will fall to about half the charge rate

selected. For specific positions, refer

to the "Ammeter" section in "Using

Your Battery Charger" on page 7.

When the battery is fully charged,

unplug the charger power cord before

attempting to disconnect charger

clamps.

Standing

away from the battery,

remove the negative

lead from the

insulated

cable connected

to the