DieHard 28.71221 Instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Ładowarka DieHard 28.71221. DieHard 28.71221 11 stron. 12v manual battery charger

8.3

Recommended minimum AWG size for extension cord:

•

100 feet long or less - use a 16 gauge extension cord.

•

Over 100 feet long - use a 14 gauge extension cord.

ASSEMBLY INSTRUCTIONS

Remove all cord wraps and uncoil the cables prior to using the battery charger.

10.

Setting the controls

All of the controls for your charger are located on the front of the charger. Read these

instructions to properly set the charger controls.

Ammeter

The Ammeter indicates the amount of current, measured in amps, that is being drawn

by the battery. As a battery takes on a charge, it draws less current from the charger.

Correspondingly, the meter will show less current being drawn by the battery. When the

current stops decreasing, the battery is charged.

The 2 amp charge rate may indicate some activity on the meter, although the meter

does not have the resolution to display this low rate. For the 2 amp charge rate, a

triangle has been provided. Its accuracy has been calibrated for use with small batteries.

•

Percent of Charge

The percent of charge is based on the current drawn by the battery. For this reason,

accuracy will vary with the size and battery type.

Charge Rate Selector Switch:

Use the Charge Rate Selector switch to select the charge rate setting you require.

11.

the assembly instructions before it is used.

The charger does not have an On/Off switch. The On and Off commands are controlled

by plugging the 71221 into a 120V AC electrical wall outlet only after the battery

connections have been made.

NOTE: Once the charger is plugged in, the battery clips are live. Make sure they are

properly connected to the battery before plugging the charger into an AC outlet or it

could cause a short circuit that may cause personal injury and/or property damage.

Ammeter

Charge Rate Selector Switch

Battery Clips

This battery charger must be properly assembled in accordance with

•