DieHard 200.71988 Instrukcja obsługi - Strona 12

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Zdalny rozrusznik DieHard 200.71988. DieHard 200.71988 16 stron. Jump starter/dc power source air compressor, inflator and ac power
Również dla DieHard 200.71988: Instrukcja obsługi (15 strony)

Drukuj stronę

14.

bEfORE USINg THE INvERTER

Important Safety Instructions:

14.1

Keep the 1150 well ventilated in order to properly disperse heat generated

while it is in use. Make sure there are several inches of clearance around

the top and sides and do not block the vents on the back of the 1150.

14.2

Make sure the 1150 is not close to any potential source of flammable

fumes, gases or clothing.

14.3

Keep the 1150 dry.

14.4

DO NOT allow the 1150 to come into contact with rain or moisture.

14.5

DO NOT operate the 1150 if you, the 1150, the device being operated or

any other surfaces that may come in contact with any power source are

wet. Water and many other liquids can conduct electricity, which may lead

to serious injury.

14.6

Do not place the 1150 on or near heating vents, radiators or other sources

of heat.

14.7

Do not place the 1150 in direct sunlight. The ideal air temperature for

operation is between 50° and 80°F.

14.8

Do not use inverter near open engine compartment where fumes or gases

may accumulate.

14.9

Do not modify the AC receptacles in any way.

15.

USINg THE INvERTER

It is important to know the continuous wattage of the device you plan to

use with the inverter. The

drawing 400 watts or less. If the wattage is not marked on the device, use

only devices that draw less than 4 Amps of AC.

Devices like TVs, fans or electric motors require additional power to start

(commonly known as the "starting or peak power"). The

1150

can supply a momentary surge in wattage; however even devices

rated less than the maximum 400 watts can exceed the inverters surge

capability and cause an automatic overload shutdown.

Make sure the device you are using is compatible with a modified sine

wave inverter.

CAUTION: Always run a test to establish whether the inverter will operate

a particular piece of equipment or device.

NOTE: In the event of a power overload, the inverter is designed to auto-

matically shut down. This safety feature prevents damaging the inverter

while testing devices and equipment with the 400-watt range.

Note: If powering more than one device, start one device at a time to

avoid a power surge and/or inverter overload. The surge load of each de-

vice should not exceed the inverter's Continuous Operation wattage rate.

Portable Power 1150

•

must be used with devices

Portable Power