Olympus Stylus 410 Skrócona instrukcja obsługi

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Aparat cyfrowy Olympus Stylus 410. Olympus Stylus 410 2 stron. Olympus camcorder/digital camera quick start guide
Również dla Olympus Stylus 410: Skrócona instrukcja obsługi (2 strony)

Drukuj stronę

Olympus Stylus 410 Skrócona instrukcja obsługi

QuickStart Guide

START HERE

It is strongly recommended that you follow these step-by-step

numbered instructions to set up and quickly begin using your

new Digital camera.

For more detailed instructions on advanced features, please refer to

the printed Basic Manual included in your package, or the Reference

Manual on the CD-ROM.

PREPARING THE CAMERA FOR USE

Before you begin using your Olympus Digital Camera...

Charging the battery

The Digital Camera uses an Olympus Lithium ion battery (LI-10B) and dedicated charger (LI-

10C). This is the only battery/charger designed for use with the Digital Camera. The battery

cannot be charged while in the camera.

Note: The Lithium ion battery is not fully charged when the camera is

purchased. You must fully charge the battery using the charger before first use.

• Insert the Lithium ion battery into the charger as indicated in the illustration.

• Connect the battery charger AC cable as shown to a standard wall outlet.

• To fully charge the battery requires approximately 2 hours. The charge indicator light will be red

when charging, and will turn green when the charging process is complete.

Loading the battery

Note: The battery and xD-Picture card compartments are accessed by opening the

respective compartment covers.

TURNING ON THE CAMERA

All you need to do is slide the lens barrier open or close to turn the camera ON or OFF.

Turning the camera ON

(SHOOTING MODE)

• Slide the lens barrier fully until it clicks. The lens extends.

• To turn the camera off, slide the lens barrier until you feel the first click. Wait until the lens is fully retracted, then

close the lens barrier all the way.

Power on

TIP

:To maximize battery life, the Digital Camera features a power saving mode in which the camera enters a sleep mode after

approximately three (3) minutes of non-use. Press the shutter button to wake up the camera.

Setting the Date and Time

Set the date and time when using the camera for the first time. This affects the way image file names are

created, and will conveniently include this information with each picture.

• With the front lens barrier closed, press

monitor. (The date and time can also be set when the camera is in the shooting mode.)

• Press

to display the top menu.

• Press

to select MODE MENU.

• Press

to select SETUP, and then press .

• Press

to select

, and then press .

• Use

to select the date format.

• Adjust the date and time in the appropriate fields by using

Repeat this step until all date/time fields have been set.

Note: Time is entered using the 24-hour format.

• Press

to store the date and time.

Camera Diagram and Controls

Now take a moment to familiarize yourself with the key areas of camera controls by reviewing the illustrations.

Card cover

Card cover catch

Connector

cover

USB

VIDEO OUT

connector

jack

VT693501

The following items are also included in the Digital Camera package: Basic Manual, A/V cable, RM-2 remote control, warranty card,

registration card (not provided in some areas).

Charge indicator

Power off

(OPTIONAL)

once. The monitor will turn on with "NO PICTURE" displayed in the

to select the field, and

Self-timer/

Flash

Remote control lamp

Lens barrier

Remote control

Lens

receiver

OLYMPUS AMERICA INC.

Olympus Europa GmbH

Two Corporate Center Drive, Melville,

Wendenstrasse 14-18,

NY 11747-3157, U.S.A.

20097 Hamburg, Germany

http://www.olympusamerica.com/support

http://www.olympus-europa.com/

UNPACKING THE BOX CONTENTS

Gather your Digital Camera and the parts as shown in the illustration. You'll need these to complete the steps for the camera

set-up procedures that follow.

Digital Camera

Strap

LI-10B lithium

ion battery

Battery charger

• Slide the battery compartment cover in the direction of the arrow, and lift

open the cover as shown in the illustration. (the direction indicated by the

mark on the cover)

• Insert the battery into the compartment.

• Close the battery compartment cover so that it pushes the battery in and

slide the cover while pressing the

Note: If the battery compartment cover is hard to close, do

not force it. Press

and then slide it into position.

• To remove the battery, make sure that the monitor and the lamp at the

side of the viewfinder are off. Return the camera to the upright position

and tip the battery out.

Inserting the xD-Picture Card

The xD-Picture Card is where the camera stores your pictures and

is available in a variety of memory capacities. The pictures you take

with the camera remain on the xD-Picture Card even when the

camera is turned off and/or the battery is removed.

• Open the connector cover while pressing the

• Open the card cover by pulling the card cover catch towards you.

• Insert the xD-Picture Card into the spring-loaded card slot as shown in

the illustration. Push the card fully into the slot. The card will lock into

place when fully inserted.

• To remove, push the card all the way in to unlock it, then let it return slowly.

• Close the card cover before closing the connector cover.

• Press

to close the connector cover.

Confirm you have installed the battery and xD-Picture Card properly by

pressing

. The "NO PICTURE" message should be displayed in the

monitor. Turn the camera off by pressing

Attaching the strap

Attach the strap as illustrated to make the camera easier to handle.

to set the proper value.

DC-IN jack

cover

Note: Depending on the camera settings, not all indicators will be displayed.

LI-10C

AC cable

CD-ROM

for the battery

(CAMEDIA Master/

charger

Reference Manual)

mark.

on the cover firmly to close the cover,

mark as in the illustration.

again.

(OPTIONAL)

Shutter button

Green lamp

Orange lamp

Viewfinder

Monitor

Monitor button (QUICK VIEW

)

Arrow pad (

)

Shooting mode button

Macro button

Flash mode button

Self-timer button

Battery

component

cover

Camera Settings in Shooting Mode as shown in Monitor

Shooting mode

Battery level

Green lamp

Flash stand-by

Macro mode

Flash mode

Self-timer/Remote control

DRIVE

Recording sound

with still pictures

2272*1704

Image quality

Resolution

Camera Settings in Playback Mode as shown in Monitor

Battery level

2272 1704

2272

1704

$04.01.01 15:30

http://www.olympus.com/

USB cable

xD-Picture Card

Zoom button

Speaker

Strap eyelet

OK/Menu button

Tripod socket

Exposure compensation

Spot metering

White balance

AF target mark

Memory gauge

Number of storable still pictures/

Remaining recording time (movie)

Print reservation (still picture)/

Movie play (playing back movies)

Playback (Recording sound)

Protect

Image quality

Resolution

Exposure compensation

White balance

Date and time

File number (still picture)/

Frame number (still picture/movie)/

Total recording time (movie)

Printed in China