AccuLine 40-6620 Instrukcja obsługi - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Poziomica laserowa AccuLine 40-6620. AccuLine 40-6620 16 stron. Self-leveling cross-line laser level
Również dla AccuLine 40-6620: Instrukcja obsługi (14 strony)

Drukuj stronę

1. Self-Check and Calibration

8. Self-Check and Calibration

IMPORTANT: It is the responsibility of the user to verify the

calibration of the instrument before each use.

1. Set the instrument on a level flat head tripod centered between two walls

(marked 1 & 2) approximately 15 feet apart. (See fig. 1).

2. Point the instrument directly at wall 1. Turn the laser on and mark the

intersection of the beams as point A.

3. Turn the instrument 180 degrees so that the laser is pointed directly at wall

2. Turn the laser and mark the intersection of the beams as point B.

4. Move the instrument and the tripod so the laser is positioned approximately

2 feet away from wall 1 (see fig. 2). Level the tripod and position the

instrument on the tripod facing wall 1. Turn the laser on and mark the

intersection of the beams as point C.

5. Turn the laser off and rotate the laser

180 degrees so that it is

facing directly to wall 2.

6. Turn on the laser and mark the inter-

section of the beams as point D.

7. Measure the distance between

points A & C.

8. Measure the distance between

points B & D.

9. If the difference between points

A & C and points B & D are less

than 1/16", your instrument is within

its tolerance.

Wall 1

Fig 2

Wall 2

Fig 1