Olympus DS 150 Instrukcja obsługi - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Rejestrator głosu Olympus DS 150. Olympus DS 150 18 stron. Olympus microcassette recorder user manual

Drukuj stronę

REPLACING THE BATTERIES

When

starts blinking on the LCD panel, replace the batteries as soon as possible.

If [BATT] and

light on the LCD panel, operation will stop. Replace the batteries immediately.

If the recorder does not function normally after the batteries have been replaced, see "RESET" on

page 32.

USING THE AC ADAPTER

E R A

Warning

Misuse of the AC adapter can result in damage, fire or electric shock. Always use the dedicated

AC adapter. Never use an adapter with different polarity or output voltage.

Stop the recorder before disconnecting the AC adapter.

When not using the recorder, always disconnect the AC adapter from the power outlet.

Plug the optional AC adapter into a house-

D IC

S P

S E

hold power outlet and connect the power plug

to the recorder's power connector (DC 3 V)

IN DE

as shown in the illustration. Do not con-

FO LD

nect the AC adapter to the recorder during

S TO

R E C

recording. Always stop recording before con-

nection. Otherwise it may not be possible to

play back the voice data being recorded.

SETTING THE CLOCK AND ID NUMBER

Once the clock and the user's ID number have been set, the user ID of the person creating the mes-

sage and the time of the day are automatically recorded in the message header. To ease manage-

ment of recorded messages, it is recommended that the clock and a 4-digit ID number be set before-

hand.

Follow the procedure below to set the clock:

ERASE SP DICT

INDEX/

In the Stop mode, press and hold the MENU switch

played on the LCD panel

Turn the MENU switch's up/down control

[Date] and [Time].

Press the MENU switch again. The cursor will blink in the year position.

Press the MENU switch's up/down control to change [Year].

When the correct year is displayed, press the MENU switch. The blinking cursor moves to the

[Month] position.

Follow the same procedure to set [Day], [Hour] and [Minute]. When the clock setting is completed,

press the MENU switch to enter the ID number setting mode. (To set only the ID number, see page

14.)

If ID number setting is not required, press the STOP button

clock setting. This completes menu setting and restores the Stop mode. (When the STOP button is

pressed, the clock starts counting seconds.)

All settings are automatically canceled after three minutes if no further operation takes place.

ERASE SP DICT

INDEX/

FOLDER

REC STOP

INDEX/

for at least 2 seconds. The menu will be dis-

in the up direction within 4 seconds to display the

instead of the MENU switch after