Olympus BX3-MDOE Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Mikroskop Olympus BX3-MDOE. Olympus BX3-MDOE 40 stron. For 2, 5, 9, 10 and 13 persons

Safety precautions

If the product is used in a manner not specified by this manual, the safety of the user may be imperiled. In addition, the

product may also be damaged. In addition, the product may also be damaged. Always use the product according to this

instruction manual.

The following symbols are used in this instruction manual.

CAUTION

NOTE

TIP

CAUTION - Installation of the product -

Install the product on a sturdy and level desk.

With this system, the product is installed on the multiple desks which are arranged side by side. All desks must be

sturdy and level. Also, take proper measures to fix the desks to avoid them from moving.

CAUTION - Electric safety -

Always use the power cord provided by Olympus.

If the proper AC adapter and the power cord are not used, the electric safety and the EMC (Electro-Magnetic

Compatibility) performance of the product cannot be assured. If no power cord is provided, please select the proper

power cord by referring to the section "Proper selection of the power cord" at the end of this instruction manual.

Always connect the ground terminal.

Connect the ground terminal of the power cord and that of the power outlet. If the product is not grounded, our

intended electric safety and EMC performance of the product cannot be assured.

Do not use the product in close proximity to the sources of strong electromagnetic radiation.

Proper operation may be interfered. The electromagnetic environment should be evaluated prior to operation of the

product.

Disconnect the power cord in case of emergency.

In case of emergency, be sure to unplug the power cord from the power cord connector on the product or from the

wall power outlet. Install the product at the location where you can reach the power cord connector or the power outlet

at hand to disconnect the power cord quickly.

Do not connect or disconnect the power cord, cables and units while the power is on.

CAUTION

Keep the power cord and cables well away from the lamp housing.

If the power cord and cables contact a hot area of the lamp housing, they could melt and cause electric shock.

Do not touch the product with wet hands.

In particular, if you touch the main switch of the power unit or the power cord with a wet hand, electric shock, ignition

or failure of the product may be caused.

: Indicates a potentially hazardous situation which, if not avoided, may result in

minor or moderate injury.

: Indicates a potentially hazardous situation which, if not avoided, may result in

damage to the product or other property and/or may cause problems.

: Indicates the useful knowledge or information for use.

- Prevention of electric shock -