Olympus BX41 Instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Mikroskop Olympus BX41. Olympus BX41 36 stron. System microscope
Również dla Olympus BX41: Instrukcja obsługi (34 strony)

Drukuj stronę

IMPORTANT

This microscope employs a UIS2/UIS (Universal Infinity System) optical design, and should be used only

with UIS2/UIS eyepieces, objectives and condensers for the BX2 series. (Some of the modules designed

for the BX series and objectives/eyepieces for the UIS series are also usable. For details, please consult

Olympus or the catalogue.) Less than optimum performance may result if inappropriate accessories are

used.

SAFETY PRECAUTIONS

Fig. 1

Fig. 2

1. After the equipment has been used in an observation of a specimen that

is accompanied with a potential of infection, clean the parts coming in

contact with the specimen to prevent infection.

· Moving this product is accompanied with the risk of dropping the

specimen. Be sure to remove the specimen before moving this

product.

· In case the specimen is damaged by erroneous operation, promptly

take the infection prevention measures.

2. Install the microscope on a sturdy, level table or bench so as not to block

the air vents on the underside of the base.

Do not place the microscope on a flexible surface, as this could result in

blocking the air vents and cause overheating or a fire.

3. To prevent obstruction of the natural convection-based air cooling of the

microscope, make sure to leave at least 10 cm of free space between

walls or other objects, and the left, right and rear sides of the microscope

and the lamp socket when installing the microscope.

4. To avoid potential shock hazards and burns when replacing the light

bulb, set the main switch @ to "

cord from the wall outlet in advance. Whenever you replace the bulb

during use or right after use, allow the lamp socket ² and bulb to cool

before touching. (Figs. 1 & 2)

Designated bulb

# The microscope also incorporate a fuse (this should be replaced by

the manufacturer or authorized agent).

5. Always use the power cord provided by Olympus. If no power cord is

provided, please select the proper power cord by referring to the section

"PROPER SELECTION OF THE POWER SUPPLY CORD" at the end of

this instruction manual. If the proper power cord is not used, product

safety and performance cannot be guaranteed.

6. Always ensure that the grounding terminal of the microscope and that

of the wall outlet are properly connected. If the equipment is not

grounded/earthed, Olympus can no longer warrant the electrical safety

and performance of the equipment.

7. Never insert metallic objects into the air vents of the microscope frame

as this could result in electrical shock, personal injury and equipment

damage.

8. The power cord may be melt by the heat of lamp socket if the cord

comes in contact with it. Distribute the power cord at an enough dis-

tance from the lamp socket.

9. The standard service life of the lamp socket is 8 (eight) years of use or

20,000 hours of total power ON period, whichever is the shorter period.

For details, see Inspection Sheet on page 30.

" (OFF) then disconnect the power

6V30WHAL (PHILIPS 5761)

(Fig. 1)