Olympus CKX41 Instrukcja obsługi - Strona 30

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Mikroskop Olympus CKX41. Olympus CKX41 36 stron. Reflected fluorescence system
Również dla Olympus CKX41: Przegląd (7 strony), Broszura i specyfikacje (4 strony), Instrukcja naprawy (43 strony)

Drukuj stronę

Fig. 21

Fig. 22

Fig. 23

Connecting the Cords

Setting the input power voltage

1. Using a flat-blade screwdriver, set the voltage switch 1 on

the rear of the power supply unit to your local power voltage.

2. Set the frequency switch 2 to your local power frequency.

# Improper setting of the above switches may degrade

burner performance, or in the worst case (although very

rare), cause the burner to explode.

Cables and cords are vulnerable when bent or twisted.

Never subject them to excessive force.

Make sure that the main switch of the power supply is

set to "

" (OFF) before connecting cables.

1. Plug the connector 3 from the burner socket securely into

the connector 4 on the power supply unit. (Fig. 22)

Always use the U-LH50HG Lamp Housing.

Always use the power cord provided by Olympus. If no

power cord is provided, please select the proper power

cord by referring to the section "PROPER SELECTION

OF THE POWER SUPPLY CORD" at the end of this

instruction manual. If the proper power cord is not used,

product safety performance cannot be warranted.

2. Connect the power cord connector 5 to connector 6 firmly.

3. Connect the power cord plug 7 to a wall outlet 8. (Fig. 23)

Be sure to supply power from a grounded, 3-conductor

power outlet using the proper power cord. If the power

outlet is not grounded properly, Olympus can no longer

warrant the electrical safety performance of the equip-

ment.

If the power cord or a connection cable comes in contact

with the lamp socket or surrounding equipment, the cord

or cable may melt and result in shock hazard. To prevent

this, distribute the cords and cables apart from the lamp

housing.

(Figs. 21 to 23)

(Fig. 22)