Olympus SZH-STAD1 Instrukcja obsługi - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Mikroskop Olympus SZH-STAD1. Olympus SZH-STAD1 34 stron. Research stereomicroscope system

2-2 Detailed Assembly Procedure

Fig. 3

Fig. 4

30°or less

Fig. 5

Installing the Pillar

1. Using the Allen wrench provided with the base, loosen the 2 clamping

screws @ on the pillar support sleeve completely.

2. Hold the pillar ² with the white rubber cap at the top, and insert it into the

pillar support sleeve until it reaches the bottom.

3. Using the provided Allen wrench, tighten the 2 clamping screws ²

securely.

Mounting the Focusing Assembly

1. First loosen the focusing assembly clamping knob @ completely, and

while holding the focusing assembly with both hands, insert the pillar ³

into the mounting hole ² from below. (Fig. 4)

# Insert slowly. Do not apply excessive force.

2. Lower the focusing assembly until it stops, then tighten the focusing

assembly clamping knob @. (Fig. 4)

To prevent the microscope from turning over, the focusing assembly

must be installed on the same side as the stage plate in the stand,

as shown in the illustration marked " " in Fig. 5, and its pivot angle

must be limited to 30°. If the focusing assembly is placed on the

wrong side, the microscope will turn over.

# If the clamping knob @ is tightened while the pillar ³ is not com-

pletely inserted into the mounting hole ², the plate spring support-

ing the pillar will deform and the pillar will not be able to penetrate

into the hole. (Fig. 4)

(Fig. 3)

(Figs. 4 & 5)