Olympus U-EXBAUG Instrukcja obsługi - Strona 13
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Mikroskop Olympus U-EXBAUG. Olympus U-EXBAUG 42 stron.
3
Objectives for Various Observation Modes
UPlanApo
PlanApo
UPlanFl
UApo
¦ : Recommended combination.
¦* : Usable but image be dark depending on NA.
–
: Not usable or applicable objective is not available.
¦** : A phase contrast objective (Ph) is necessary for phase contrast observation. The Ph objective is not
4
Turning the Power Supply Unit On
Set the main switch to " I " (ON). The arc image will stabilize in 5 to 10 minutes after ignition.
}The mercury burner may not be ignited from the beginning due to variance between individual products. In this case, set
the main switch to "
# To extend the mercury burner life, do not turn the mercury burner off for 15 minutes after ignition.
# The mercury burner cannot be ignited until the mercury vapor has cooled down and liquefied. Before re-igniting
a mercury burner, wait for about 10 minutes after the last time it was turned off.
}For the shake of safety, the power supply to the lamp housing is shut down if the lamp housing is opened while the
burner is on. If this happens, set the main switch to "
Do not open the lamp housing until it has cooled down enough.
# To reset the hour counter, hold its reset button until "000.0" is displayed.
10
Objective
4X
10X
10XO
10XW
20X
20XO
40X
40XO I
60X
60XW
100XO I
40X
60XO
100XO
4X
10X
20X
40X
60XOI
100XO, OI
20X
20XW/340
40X
40XO I
40XW/340
available for the UPlanFI100XOI.
" (OFF), wait for 5 to 10 seconds, then set it again to " I " (ON).
Reflected Light Fluorescence
U, V, BV
B, IB, G, IY
¦
¦
¦
¦
¦
¦
¦
¦
¦
¦
¦
¦
¦
¦
¦
¦
¦
¦
¦
¦
¦
¦
–
¦
¦
¦
–
¦
*¦*
*¦*
*¦*
*¦*
*¦*
*¦*
*¦*
*¦*
¦
¦
¦
¦
¦
¦
¦
¦
¦
¦
¦
¦
¦
¦
" (OFF), wait for ore than 10 minutes, then set it again to " I " (ON).
Phase Contrast
Transmitted Light
Difference
Nomarski DIC
–
–
**¦**
¦
–
¦
–
–
**¦**
¦
–
¦
–
¦
**¦**
¦
–
–
–
¦
**¦**
¦
–
–
**¦**
¦
–
–
–
–
**¦**
¦
**¦**
¦
**¦**
¦
**¦**
¦
**¦**
¦
–
¦
–
¦
–
¦
–
¦
–
¦