Olympus SHV-1 Instrukcja obsługi - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Akcesoria do kamer Olympus SHV-1. Olympus SHV-1 11 stron. Flash high voltage set
Drukuj stronęConnection to the flash system
This product has been designed exclusively for use with the OLYMPUS digital camera electronic
flash system.
3
Remove the protective
cap before connection.
1
2
Remove the cover before
connection.
Note
• When plugging or unplugging the connection cable, always hold the plug . Do not pull it by the cord.
Turning the flash system on
1
3
• When using the HV-
1, keep it in the hard
case to protect the
attached battery
pack.
18
1.
Set the HV-1 power switch to OFF.
2.
Connect the connection cable to the connection cable ter-
minal of the HV-1 as shown.
3.
Connect the other end of the connection cable to the ex-
ternal power supply connector of the electronic flash.
1.
Set the HV-1 power switch to ON.
2.
Set the electronic flash power switch to ON.
2
3.
Check the status of the indicator lamp on the HV-1.
Lamp Status
Extinguished
Green lighting
Orange blinking
Red blinking
Memo:
Note
• If the indicator lamp blinks in red while the battery pack is attached
correctly as described in this manual, unplug the power cord from the
wall outlet and contact Olympus.
Memo:
After removing the protective cap from
the electronic flash, store the cap in
the protective cap storage position of
the HV-1 as shown.
Error (Temperature error)
Always turn the HV-1 on before turning the electronic flash on.
Since the HV-1 supplies control power to the electronic flash,
the electronic flash can be used without the battery pack. In
this case, however, note that battery charge time increases
and the flashing count decreases.
Operating Status
Power OFF
Normal operation
Charge request