Axkid Rekid Instrukcja obsługi - Strona 13
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Fotelik samochodowy Axkid Rekid. Axkid Rekid 16 stron.
Drukuj stronę
7
5
6
9
11
anchoring point needs to be as close to the floor
as possible. In doing so you you should always
insert the buckle through the closest appropri-
ate slot in the strap tp create a slip knot then
pull tight. This needs to be repeated on both
sides to create two anchor points. When install-
ing Rekid in the front passenger seat the tether
straps must be attached to the front gliding
tracks so the tether points will be located along
the front edge of the passenger seat.
Pull out the upper anchorage strap from the
belt housing (5) to an appropriate length.
Check that the white marking on the strap
(6) is visible. If not, you can try crossing the
straps over to give them some extra length
to enable the white marking to be visible.
Clip the anchor attachment directly onto the
anchorage point. Repeat on the other side.
Press down hard on the top right side of the
child restraint then repeat for the left side(7).
When you do this its important that you re-
8
ally use your full body weight to press down
and get the tether straps to really tighten
hard. This will give the anchorage straps their
first tightening.
Unfold the support leg out to its maximum
angle. Pull out the top latch to release the up-
per part of the support leg (8) until it reaches
the floor. If the support leg does not reach the
floor, repeat with the lower latch(9). Its impor-
tant that you check that the support leg is an
angle over 80 degress from the back of the
10
seat. You could check this by ensuring that
the support leg is further away from the seat
then the vertical line(10).
Press down on the child restraint from
side to side again, the anchorage straps will
be then be automatically tightened.
13
Continued on next page