Olympus CKX41 Instrukcja obsługi - Strona 22

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Sprzęt laboratoryjny Olympus CKX41. Olympus CKX41 36 stron. Reflected fluorescence system
Również dla Olympus CKX41: Przegląd (7 strony), Broszura i specyfikacje (4 strony), Instrukcja naprawy (43 strony)

Drukuj stronę

Problem

b) The main switch can be set

to ON but the burner does

not ignite.

c ) The mercury burner flickers

or the brightness is low.

d) The service lives of mercury

burners are very short.

Cause

The lamp housing connecting

cord is connected improperly.

The mercury burner is not

mounted.

The safety mechanism in the

lamp housing is activated.

The auto ignition system is mal-

functioning.

The auto ignition safety mecha-

nism is activated.

This phenomenon is observed

in a short period after ignition.

The power supply voltage

and/or frequency switches are

set improperly.

The burner life has expired.

The power supply voltage is set

improperly.

Remedy

Connect it properly to the con-

nectors.

Attach a mercury burner.

Tighten the lamp burner socket

clamping screw firmly.

Set the main switch of the power

supply unit to " " (OFF) then " "

(ON) again.

(Repeated ON-OFF is possible

in this case.)

Press the switch inside the

starter reset hole on the right

panel of the power supply unit,

and then set the main switch to

" " (ON) again.

Wait for 10 minutes or more

after ignition.

Set them properly.

Replace the mercury burner.

Set it properly.

Page

25, 26