Olympus MX61A Podręcznik - Strona 31

Przeglądaj online lub pobierz pdf Podręcznik dla Sprzęt laboratoryjny Olympus MX61A. Olympus MX61A 48 stron. Motorized 300 mm compatible semiconductor/fpd inspection microscope

Drukuj stronę

CONFIG 1/6 screen

Objective name selection 1/3 screen

...

Objective magnification selection screen

CONFIG 1/6 Screen Setup

}When any of the CONFIG screens is displayed, the MX-HS61A hand

switch cannot be used except for the jog dial.

}The CONFIG 1/6 screen is used to set the basic configuration of the

microscope.

Setting the Name and Magnification of Objective (OB)

}When a 5-position revolving nosepiece is used, the switches for data 6

are grayed out.

1. If an objective name displayed as the default is incorrect, touch the

switch @ below the objective name to open the objective name selec-

tion screen.

2. Touch the desired objective name ² and touch the OK switch ³ to enter

it. If the desired objective name is not shown in the objective name se-

lection screen, touch the page up/down switch | until the desired ob-

jective name is displayed (a total of 3 pages are provided).

3. When the objective name is entered with the OK switch, the CONFIG 1/

6 screen is displayed again.

4. If the displayed objective magnification is incorrect, touch the

ƒ below the magnification to open the objective magnification selection

screen.

5. Touch the correct objective magnification ... and touch the OK switch †

to enter it.

6. Correct other objective names and types if they are incorrect.

}Set the idle position (- - -) for the objective No. where an objective is not

mounted. This omits unnecessary setup operations. After the objective

No. is set as the idle position, the objective name will be "NONE".

†

MX61A

switch