Axminster MCB100A Podręcznik użytkownika - Strona 10

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Piła Axminster MCB100A. Axminster MCB100A 20 stron. 4" metal cutting bandsaw

7.Operating

INFORMATION BEFORE OPERAION

Be sure the table isn't in contact with the

work when the motor is started.

Run the motor, allow the saw to come to full

speed. Begin the cut by letting the head

down slowly onto the work.

DO NOT DROP OR FORCE. Let the weight

of the saw provide the cutting force. The saw

shuts off at the end of the cut automatically.

The rate of feed is preset (On Mark H) at the

factory for solid metal material cutting.

To decrease feed, proceed as follows:

1. Release the lock-pin by pulling up the

Knob (A) in Fig. 3 a little bit.

2. Turn the wheel (B) toward the Knob and

stop on the Mark M, let the lock pin slide

in the slot. The rate of feed is for thick

metal pipes cutting.

3. Turn the wheel and stop on the Mark L

and lock it on the position, the rate of

feed is for thin metal pipes cutting.

The machine uses a swivel miter base for

angle cutting from 0~45 degree. On the

swing arm, there is a pointer (A) in Fig. 4

attached. This machine is preset zero degree

before leaving the factory. Angle cutting is

adjusted as follows.

1. Loosen bolt (B) to release the arm.

2. Move this swivel arm forward along the

scale that is for searching a right angle

for the work to be cut.

3. If the pointer is matched by the right

degree on the scale. Tighten the bolt, and

a perfect angle cut will be given.

Fig. 3

Fig. 4

B L A D E D I R E C T I O N O F T R AV E L

Be sure this blade is assembled to the

wheels such that the vertical edge can

engage the work piece first.