Axminster SIEG G1 Engineer Series Podręcznik użytkownika - Strona 11
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Piła Axminster SIEG G1 Engineer Series. Axminster SIEG G1 Engineer Series 16 stron. Powered hacksaw
Również dla Axminster SIEG G1 Engineer Series: Podręcznik użytkownika (16 strony)
Drukuj stronę
Operation of the Powered Hacksaw...
This is a very simple machine to operate, there are no choices of speeds or down-feed
settings to select.
The arm has a supporting gas strut to take some of the weight of the arm and allow the arm
to descend in a controlled fashion.
When you raise the arm, there is a latching arm that will drop into place to support the arm
in the raised position. (See Fig A)
When you wish to begin cutting, lower the arm onto the material and press the ON (green)
button on the switch. (See Fig C)
DO NOT lean on the arm to increase the cutting rate.
Use the length stop assembly to create identical lengths of materials. (See Fig B)
The machine should switch off automatically when the cut is completed, if the machine does
not switch off, press the STOP (red) button manually. Disconnect the power supply and
adjust the stop actuator mounted on the lower part of the arm so that it pushes the stop
button down further.
Fig B
Fig C
Fig A
Length stop
Lower the arm onto
Latching arm
assembly
the material ready
for cutting
11