Axminster 100714 Podręcznik użytkownika - Strona 4

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Narzędzia Axminster 100714. Axminster 100714 8 stron. Single hinge jig

Using the Template

Using the template to cut 100mm

hinge recesses in the door edge

1. The template is first adjusted to position the hinge

knuckle or pivot pin on the door edge to ensure that

the door will close correctly to the doorframe. The

inside edge of the template is set to the width of

the hinge flap plus the guide bush margin. (See fig

01)The guide bush margin is simply the difference

between the cutter diameter and the outside guide

bush diameter, divided by two. Using the suggested

26mm guide bush and a 20mm cutter, the margin will

be 3mm. As the template opening is 106mm, using

this combination will leave a recess length of 100mm

or the length of the hinge. Imperial 4inch long hinges

will require a 25mm guide bush and the 20mm cutter.

Fig 01

Template

NOTE. This formula can be used to calculate any

recess length to accommodate variations in the

hinge length. For example a 75mm hinge recess

cut using the 106mm template will require a

guide bush diameter of 40mm and a cutter

diameter of 9mm. 106 - 75 = 31. Using a 40mm

guide bush = 40 - 31 = 9mm diameter cutter.

2. Mark out the centre line of the hinge positions on

the door edge. (See fig 02) Clamp the box section of

the jig, with the open edge of the template on the

hanging (i.e. pivot edge) face of the door. (See fig 03)

Align the engraved centre line on the template with

the hinge centre line marked on the door edge.

Check that the template edge is square to the door

face before tightening the locking knobs. Do not

over tighten as this may damage the template.

Marking out the centre line of the hinge positions on

the door edge

Hinge

Clamping the box section of the jig

3. Fit the correct diameter guide bush and cutter to

the router to achieve the length of recess to suit the

hinge. (See fig 04) As the template thickness is 6mm,

the guide bush depth beneath the router base must

be slightly less than this.

Fig 02

Centre line

Fig 03