Axminster AW19FM Podręcznik użytkownika - Strona 11

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Narzędzia Axminster AW19FM. Axminster AW19FM 12 stron. Morticers
Również dla Axminster AW19FM: Podręcznik użytkownika (20 strony)

Drukuj stronę

Illustrated Parts Breakdown for AW19FM...

A X M I N S T E R

W H I T E

1. Set the depth of the mortice with the lower of the two depth stops (Fig C) on page 8.

The upward travel of the head can be limited by adjusting the upper stop; this prevents

unnecessary movement of the operating handle when cutting shallow mortices.

2. Place the workpiece on the table and clamp in position with the vice or the hold down

clamps. Use the left handwheel to move the table forwards and backwards in order to

position the mortice in the required position across the timber.

3. Adjust the two table stops shown in Fig D on page 9 to give the required length of

mortice and tighten up the two thumbscrews.

4. Turn the machine on and feed the chisel and bit steadily into the work by pulling down on

the operating handle. The handle can be re-positioned on its spindle so that it is in the most

convenient position.

5. After making the first cut, the table is moved along with the left hand wheel for successive

cuts until the mortice is complete. The direction of movement of the table will depend on

which side of the chisel the clearance slot is located - movement should be away from the

slot so that the chippings can clear freely.

6. The rate of feed of the chisel should be fast enough to prevent burning of the tip of the

chisel but not so fast as to risk breaking the auger. The ideal speed for any combination of

chisel size and timber type will be learned through experience.

7. Deep mortices are best cut in a series of shallower cuts to allow the chippings to clear

and prevent blocking of the chisel.

This section refers only to the AW19FTH Morticer

Table & Column Tilt Control

To avoide the morticer from becoming top

heavy and tipping over we advise you DO

WARNING!!

NOT angle the Column and Table beyond

21˚degrees.

Setting the Table Angle

Loosen the caphead bolt (E) below the left sized of

the table using a 8mm alan key (See figs 1,4,4a). Turn

the handwheel (F) clockwise or anti-clockwise to set

the angle on the scale. (See fig 3) When the required

angle is reached, re-tighten the caphead bolt (E).

(See fig 4a)

Setting the Column Angle

On the tilt column assembly loosen the caphead bolt

with a 8mm alan key (E) (See figs 1, 5a), pull and turn

the column lock pin (G) towards you to un-lock the

column & to prevent the pin from spring back into the

recess. (See fig 5a) Turn the column handwheel (F)

(clockwise or anti-clockwise), to set the angle on the

scale. (See figs 2,3) Once the required angle is

reached, turn and push the column lock pin (G) back

into the recess then re-tighten the caphead bolt (E)

on the column.

Operating Instructions...

Fig 1

Fig 2

A X M I N S T E R

W H I T E