Axminster Digital Height Gauge Podręcznik użytkownika - Strona 5

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Narzędzia Axminster Digital Height Gauge. Axminster Digital Height Gauge 8 stron.

Illustration & Description...

Please study the illustrations, so that you may understand the terminology we have used,

and better understand the operation of your Digital Height Gauge. Note the positions and

the functions of the various buttons on the Digital Readout, these will be more fully

explained a little later in the text:-

The gauge comprises a precision machined alloy block, into which the Linear Scale of the

Digital Readout (DRO) is bolted. This fixing is set very precisely at right angles to the base,

to ensure accurate measurement. The linear scale is also marked with Analogue Scales from

0-6" and from 0-150mm. These scales are read against the lower edge of the DRO.

There are three Rare Earth Magnets set into the base of the block, to enable/aid the gauge

to be held flat against a ferrous metal surface. Please Note. The magnets are not

sufficiently strong to support the whole weight of the gauge on a vertical surface; although

the base will remain in flat contact with the surface the gauge is liable to slip.

The digital readout is mounted on the linear scale and has an 'L ' shaped pointer attached to

it; there is also a small Locking Screw with a serrated knob; that will clamp the DRO in

position if tightened (Do not over tighten). NOTE Please ensure the locking screw is

loosened before attempting to move the gauge.

The Battery Compartment is on the lower front face of the DRO and can be opened by a

'press down' and slide motion in the direction of the 'arrow' thumb grip. If you are replacing

the battery ensure that it is positioned with the + marking uppermost.

The 'L' shaped pointer is ground to a fine edge to enable the most accurate measurement; it

is also hardened so that the points can be used for scribing lines at the set height.

P .S. When scribing, please hold the pointer only, DO NOT apply pressure by gripping the

gauge proper

Pointer

Router Cutter

Picture shows the digital

height guage being used to

measure the depth of the

router cutter.